project/bcm63xx/u-boot.git
2015-07-28 Michal Simekspi: zynq_spi: Simplify debug macro
2015-07-28 Michal Simekzynq: Fix typo in Makefile about custom ps7_init file
2015-07-28 Michal Simeknet: gem: Extend timeout value
2015-07-28 Michal Simekzynqmp: Show EL level where U-Boot runs
2015-07-28 Michal SimekARM: zynqmp: Wire up SATA for the board
2015-07-28 Michal SimekARM: zynqmp: Wire up ethernet controllers
2015-07-28 Michal SimekARM: zynq: Add support for zc770-xm011
2015-07-28 Michal SimekARM: zynq: DT: Update zc770 dtses
2015-07-28 Michal SimekARM: zynq: DT: Add zc702 pushbuttons to DT as gpio...
2015-07-28 Michal SimekARM: zynq: DT: Add missing interrupt for L2 pl310
2015-07-28 Michal SimekARM: zynq: DT: Get rid of ps-clk-frequency
2015-07-28 Michal SimekARM: zynq: DT: Update years in copyright
2015-07-28 Michal SimekARM: zynq: DT: Sync zc702/zc706/zed/zybo DT with kernel
2015-07-28 Michal SimekARM: zynq: DT: Add reference to bus node
2015-07-28 Michal SimekARM: zynq: DT: Add pinctrl node
2015-07-28 Michal SimekARM: zynq: DT: Cleanup address-cells and size-cells
2015-07-28 Michal SimekARM: zynq: DT: Clean up timer device tree nodes
2015-07-28 Michal SimekARM: zynq: DT: Use the zynq binding with macb
2015-07-28 Michal SimekARM: zynq: DT: Fix GEM register area size
2015-07-28 Michal Simekspi: Fix zynq SPI binding
2015-07-28 Michal SimekARM: zynq: DT: Remove 222 MHz OPP
2015-07-28 Michal SimekARM: zynq: DT: Migrate UART to Cadence binding
2015-07-28 Michal SimekARM: zynq: DT: Add a fixed regulator for CPU voltage
2015-07-28 Michal SimekARM: zynq: DT: Add missing nodes to DTSI
2015-07-28 Michal SimekARM: zynq: DT: Use the right names for nodes
2015-07-28 Michal Simekzynqmp: Add support for IP detection via SLCR
2015-07-28 Michal Simekzynqmp: mp: Simplify set_r5_start handling
2015-07-28 Siva Durga... zynqmp: Provide option to enable uart dcc support for...
2015-07-28 Siva Durga... Kconfig: zynqmp: Move CONFIG_SYS_TEXT_BASE to defconfig
2015-07-28 Siva Durga... zynqmp: Define ep config for ZynqMP
2015-07-28 Siva Durga... zynqmp: Kconfig: Move zynqmp Kconfig
2015-07-28 Michal Simekzynq: gem: Setting up WRAP bit for one TX bd
2015-07-28 Siva Durga... zynq: gem: Increase the Rx buffer descriptors to 32
2015-07-28 Siva Durga... zynqmp: gem: Flush the rx buffers while transmitting
2015-07-28 Siva Durga... zynqmp: gem: Set data bus width to 64bit for arm64
2015-07-25 Tom RiniMerge branch 'master' of git.denx.de/u-boot-sunxi
2015-07-25 Hans de Goedesunxi: Enable both ehci and otg in host mode on various...
2015-07-25 Hans de Goedesunxi: ga10h: Enable both otg and regular usb host...
2015-07-25 Hans de Goedesunxi: musb: Stop treating not having a vbus-det gpio...
2015-07-25 Hans de Goedesunxi: musb: Improve output during probing
2015-07-25 Hans de Goedesunxi: musb: Use device-model for musb host mode
2015-07-25 Hans de Goedesunxi: musb: Move musb config and platdata to the sunxi...
2015-07-25 Hans de Goedesunxi: musb: Add id pin support
2015-07-25 Hans de Goedesunxi: musb: Move vbus check to sunxi_musb_enable
2015-07-25 Hans de Goedesunxi: usb-phy: Add support for reading otg id pin...
2015-07-25 Hans de Goedesunxi: Enable CMD_USB and USB_STORAGE by default on...
2015-07-25 Tom Rinisunxi: Update selects in arch/arm/Kconfig for DM conver...
2015-07-25 Hans de Goedesunxi: Remove bogus uart entry from utoo-p66 dts file
2015-07-24 Tom RiniMerge git://git.denx.de/u-boot-usb
2015-07-24 Rob Herringusb: ci_udc: fix request allocation when endpoints...
2015-07-24 Daniel Kochmańskisunxi: spl: Remove redundant check from `board_mmc_init...
2015-07-24 Daniel Kochmańskisunxi: spl: Detect at runtime where SPL was read from
2015-07-24 Daniel Kochmańskisunxi: Create helper function veryfing valid boot signa...
2015-07-24 Daniel Kochmańskimmc: Protect `mmc_initialize` from initialising mmc...
2015-07-24 Stefan Roesearm: marvell: Increase MAXARGS to 32
2015-07-24 Stefan Roesearm: mvebu: db-88f6820-gp: Add SDIO/MMC SPL boot support
2015-07-24 Stefan Roesespl: spl_mmc: Add option to boot from a MMC partition...
2015-07-24 Stefan Roesekwbimage: Rename CONFIG_SYS_SPI_U_BOOT_OFFS to CONFIG_S...
2015-07-24 Stefan Roesekwbimage: Add support for SDIO/MMC boot device selection
2015-07-24 Stefan Roesearm: mvebu: Add SPL SDIO/MMC boot support
2015-07-23 Tom RiniMerge git://git.denx.de/u-boot-uniphier
2015-07-23 Masahiro YamadaARM: UniPhier: document reference support card
2015-07-23 Masahiro YamadaARM: dts: UniPhier: add I2C ch4 device node for PH1...
2015-07-23 Masahiro YamadaARM: UniPhier: add PH1-sLD3 SoC support
2015-07-23 Masahiro YamadaARM: UniPhier: update CONFIG_BOOTARGS
2015-07-23 Masahiro YamadaARM: UniPhier: disable CONFIG_FIT
2015-07-23 Masahiro YamadaARM: UniPhier: add environment variable for TFTP boot
2015-07-23 Masahiro YamadaARM: UniPhier: add environment sets for non-FIT Linux...
2015-07-23 Masahiro YamadaARM: dts: UniPhier: add device-specific compatible...
2015-07-23 Tom RiniMerge git://git.denx.de/u-boot-marvell
2015-07-23 Stefan Roesearm: mvebu: db-88f6820: Add SPL support with DDR init...
2015-07-23 Stefan Roesearm: mvebu: a38x: Use correct PEX register access macros
2015-07-23 Stefan Roesearm: mvebu: Add Armada 38x DDR3 training code from...
2015-07-23 Stefan Roesearm: mvebu: drivers/ddr: Move Armada XP DDR init code...
2015-07-23 Stefan Roesearm: mvebu: Add Armada 38x SERDES / PHY init code from...
2015-07-23 Stefan Roesearm: mvebu: serdes: Move Armada XP SERDES / PHY init...
2015-07-23 Stefan RoeseMakefile: Fix mvebu build target to use SPL load and...
2015-07-23 Stefan Roesearm: mvebu: Disable MMU before changing register base...
2015-07-23 Stefan Roesearm: mvebu: spl.c: Add call to board_early_init_f()
2015-07-23 Stefan Roesearm: mvebu: Use default reg base address for SPL on...
2015-07-23 Stephen Warrenci_udc: fix 64-bit compile warnings
2015-07-23 Stefan Roesearm: mvebu: Call timer_init early before PHY and DDR...
2015-07-23 Anton Schubertarm: mvebu: add Armada XP SATA support
2015-07-22 Masahiro Yamadalinux_compat: handle __GFP_ZERO in kmalloc()
2015-07-22 Masahiro Yamadalinux_compat: move vzalloc() to header file as an inlin...
2015-07-22 Masahiro Yamadalinux_compat: remove cpu_relax() define
2015-07-22 Masahiro Yamadax86: delete unneeded declarations of disable_irq()...
2015-07-22 Stefan Roeseusb: ehci-marvell: Drop wrl accessor function
2015-07-22 Paul Kocialkowskiusb: CONFIG_USB_FASTBOOT prefix replacement for consistency
2015-07-22 Jiandong Zhengimplement Fastboot via USB OTG on bcm28155_ap boards
2015-07-22 Jiandong Zhengusb: gadget: bcm_udc_otg files
2015-07-22 Steve Raeg_dnl: add missing declaration
2015-07-22 Paul Kocialkowskiusb: gadget: fastboot: Dequeue the previous IN request...
2015-07-22 Paul Kocialkowskiusb: gadget: fastboot: Request status and length check...
2015-07-22 Paul Kocialkowskifastboot: Dynamic controller index for usb_gadget_handl...
2015-07-22 Paul Kocialkowskiusb: gadget: Weak board_usb_init/cleanup definitions...
2015-07-22 Paul Kocialkowskiusb: board_usb_init and board_usb_cleanup calls in...
2015-07-22 Paul Kocialkowskiusb: Fastboot function config for better consistency...
2015-07-22 Paul Kocialkowskiusb: USB download gadget and functions config options...
2015-07-22 Nikhil Badoladrivers: usb: fsl: Remove LS102XA immap inclusion
next