project/bcm63xx/u-boot.git
2018-05-11 Vipul Kumarmmc: Changed the datatype of the variable to handle...
2018-05-11 Michal Simekarm: zynqmp: Add ZynqMP minimal R5 support
2018-05-11 Alexander Graftools: zynqmpimage: Add bif support
2018-05-11 Alexander GrafMAINTAINERS: Declare tools/zynqmp* as Xilinx maintained
2018-05-11 Alexander Graftools: zynqmpimage: Move defines to header
2018-05-11 Alexander Graftools: zynqmpimage: Add partition read support
2018-05-11 Michal Simekarm64: zynqmp: Show model information instead of custom...
2018-05-11 Michal Simekarm64: zynqmp: Simplify boot_target variable composition
2018-05-11 Nitin Jainarm64: zynqmp: Setup MMU map for DDR at run time
2018-05-11 Michal Simekarm64: zynqmp: Enable cadence WDT for zcu100
2018-05-11 Michal Simekarm64: zynqmp: Wire watchdog internals
2018-05-11 Michal Simekwatchdog: cadence: Show used timeout value
2018-05-11 Michal Simekarm64: zynqmp: Reset FPD Watchdog on zcu100
2018-05-11 Siva Durga... nand: zynq: Send address cycles as per onfi parameter...
2018-05-11 Siva Durga... nand: zynq: Add support for 16-bit buswidth
2018-05-11 Michal SimekMAINTAINERS: zynqmp: Point to proper zynqmp folder
2018-05-11 Michal Simekserial: zynq: Remove header depedency on arm header...
2018-05-11 Michal Simektimer: Add Cadence TTC timer counter support
2018-05-11 Siva Durga... microblaze: Dont enable UBI support by default
2018-05-11 Siva Durga... arm64: zynqmp: Add new defconfig for zc1275 revB
2018-05-11 Michal Simekscsi: ceva: Convert driver to use UCLASS_AHCI instead...
2018-05-11 Michal Simekarm: zynq: Remove checkboard and enable DISPLAY_CPUINFO
2018-05-11 Michal Simekarm: zynq: Rework FPGA initialization
2018-05-11 Michal Simekarm: zynq: Enable debug_uart_init in spl when enabled
2018-05-10 Tom RiniMerge git://git.denx.de/u-boot-ubi
2018-05-09 Tom RiniMerge git://git.denx.de/u-boot-sunxi
2018-05-09 Patrice Chotardubifs: avoid assert failed in ubifs.c
2018-05-08 Tom Rinibootm.c: Correct the flush_len used in bootm_load_os()
2018-05-08 Clément Péronimage: fit: Show signatures and hashes for configurations
2018-05-08 Grygorii Strashkoarm: bitops: fix find_next_zero_bit() for case size...
2018-05-08 Neil Armstrongcmd: add ADC cli commands
2018-05-08 Mario Sixpci: Don't use pci_indirect when DM is active
2018-05-08 Mario Sixgdsys: drivers: Add gdsys_rxaui_ctrl driver
2018-05-08 Mario Sixclk: Add ICS8N3QV01 driver
2018-05-08 Mario Sixihs_mdio: Make DM-compatible
2018-05-08 Mario Sixihs_mdio: Encapsulate register access
2018-05-08 Ramon Frieddb410c: set clk node to be probed before relocation
2018-05-08 Patrice ChotardARM: dts: sti: Add stih410-b2260-u-boot.dtsi
2018-05-08 Sam Protsenkoarm: ti: boot: Extract PARTS_DEFAULT to boot.h
2018-05-08 Tom RiniMerge git://git.denx.de/u-boot-mmc
2018-05-08 Tom RiniMerge git://git.denx.de/u-boot-uniphier
2018-05-08 Tom Rinilib/Kconfig: Mark OF_LIBFDT_OVERLAY as depending on...
2018-05-08 Neil Armstrongadc: add Amlogic Meson SAR ADC driver
2018-05-08 Neil Armstrongtest: regmap: add read/modify/write test
2018-05-08 Neil Armstrongregmap: add regmap_update_bits() helper
2018-05-08 Patrice ChotardARM: dts: stm32mp157: Add vrefbuf DT node
2018-05-08 Fabrice Gasnierconfigs: stm32mp15: Enable STM32_VREFBUF flag
2018-05-08 Fabrice Gasnierclk: stm32mp1: Add VREF clock gating
2018-05-08 Fabrice Gasnierpower: regulator: Add support for stm32-vrefbuf
2018-05-08 Patrice Chotardconfigs: stm32mp15_basic: Set regulator relative flags
2018-05-08 Patrice ChotardARM: dts: stm32mp157c-ed1: Add regulator node
2018-05-08 Patrice Chotardpower: pmic: stpmu1: Add regulator bindings
2018-05-08 Christophe... power: regulator: stpmu1: Introduce stpmu1 driver
2018-05-08 Patrice ChotardARM: dts: stm32mp157: Add SoC pwr regulator entry
2018-05-08 Patrick Delaunaystm32mp: regulator: add SoC pwr regulator support
2018-05-08 Mario Sixarm: controlcenterdc: Add spi-flash compatible strings
2018-05-08 Praneeth Bajjurienv: ti: android: boot with FIT Image
2018-05-08 Praneeth Bajjuriconfigs: TI: Enable FIT Library overlay support
2018-05-08 Praneeth Bajjuriarm: dra76: fastboot: extend cpu type for getvar command
2018-05-08 Ludovic Desrochesdefconfig: at91-sama5d2_ptc_ek: remove unused SYS_EXTRA...
2018-05-08 Eugen Hristevboard: sama5d27_som1_ek: Fix the USB vbus power
2018-05-08 Eugen Hristevconfigs: at91: sama5: updated mtdparts variable in...
2018-05-08 Eugen Hristevboard: sama5d2_ptc_ek: adjust the smc timings of nand
2018-05-08 Ludovic Desrochesgpio: atmel_pio4: give a full configuration when muxing...
2018-05-08 Ludovic Desrochesboard: atmel: sama5d2_ptc_ek: update pin configuration...
2018-05-08 Ludovic Desrochesgpio: atmel_pio4: add drive strength macros
2018-05-08 Ley Foon Tanpci: intel: Add Intel FPGA PCIe controller driver
2018-05-08 Michalis Pappasarm64: Add SMC and HVC commands
2018-05-08 Neil Armstrongpinctrl: meson: Update pinmux with new Linux bindings
2018-05-08 Neil ArmstrongARM64: meson: Sync DT and Bindings with Linux 4.16
2018-05-08 Neil ArmstrongARM: meson: rename GXBB to GX
2018-05-08 Patrice Chotardclk: clk_stm32f: Use PLLSAIP as USB 48MHz clock
2018-05-08 Patrick Bruenndm: led: add testcase for "default-state" property
2018-05-08 Patrick Bruenndm: led: auto probe() LEDs with "default-state"
2018-05-08 Patrick Bruenndm: led: Support "default-state" property
2018-05-08 Jassi Brarmmc: support writing sparse images
2018-05-08 Andy Yanpower: pwm regulator: support live tree
2018-05-08 Patrick Bruenndm: mmc: socfpga: call dwmci_probe()
2018-05-08 Jaehoon Chungmmc: Kconfig: add the MMC_TRACE config in Kconfig
2018-05-08 Jaehoon Chungmmc: add the debug message in mmc_set_clock
2018-05-08 Jaehoon Chungmmc: add the MMC_CLK_ENABLE/DISABLE macro in mmc.h
2018-05-08 Jaehoon Chunglib: fdtdec: drop the old compatible about max77686
2018-05-08 Jaehoon Chungpower: pmic_max77686: remove the old pmic_max77686...
2018-05-08 Jaehoon Chungconfigs: trats2: enable the max77686 regulator config
2018-05-08 Masahiro YamadaARM: uniphier: enable CONFIG_PINCONF
2018-05-08 Masahiro Yamadapinctrl: uniphier: add ethernet TX pin data for LD20
2018-05-08 Masahiro Yamadapinctrl: uniphier: support drive-strength configuration
2018-05-08 Masahiro Yamadapinctrl: uniphier: support per-pin configuration via DT
2018-05-08 Masahiro Yamadapinctrl: uniphier: include <linux/build_bug.h> instead...
2018-05-08 Masahiro Yamadapinctrl: uniphier: replace printf() with dev_err()
2018-05-08 Masahiro Yamadapinctrl: uniphier: remove unneeded pin data of LD6b SoC
2018-05-08 Jassi Brarfastboot: sparse: make write_sparse_image useable for...
2018-05-08 Jassi Brarfastboot: sparse: remove redundant argument to write_sp...
2018-05-07 Lokesh Vutlaarm: v7R: Add support for enabling caches
2018-05-07 Lokesh Vutlaarm: v7R: Add support for MPU
2018-05-07 Michal Simekarm: v7R: Add initial support
2018-05-07 Lokesh Vutlaarm: v7: Kconfig: Introduce SYS_ARM_CACHE_CP15
2018-05-07 Lokesh Vutlaarm: v7: Kconfig: Add entry for MMU
2018-05-07 Lokesh Vutlaarm: v7: Kconfig: Rename CPU_V7 as CPU_V7A
2018-05-07 Lokesh Vutlaarm: v7: Update VBAR only if available
next