project/bcm63xx/u-boot.git
2017-11-29 Michal Simekarm: zynq: Show information about silicon version
2017-11-29 Michal Simekarm: zynq: Do not show information from checkboard...
2017-11-29 Michal Simekarm: zynq: Use unsigned type with comparison with ARRAY...
2017-11-29 Michal Simekarm: zynq: Convert all board to use arch ps7_init code
2017-11-29 Michal Simekarm: zynq: Add support for EMIT_WRITE operation
2017-11-29 Michal Simekarm: zynq: Add ps7GetSiliconVersion() to ps7_spl_init
2017-11-29 Michal Simekarm: zynq: Move common ps7_init* initialization to...
2017-11-29 Michal Simekarm: zynq: Get rid of ps7_reset_apu() for syzygy board
2017-11-29 Michal Simekarm: zynq: Move ps7_* to separate file
2017-11-29 Michal Simekarm: zynq: Remove ps7_debug code
2017-11-29 Michal Simekarm: zynq: Enable debug uart on zc706
2017-11-29 Michal Simekarm: zynq: Add missing ps7_post_config declaration
2017-11-29 Siva Durga... net: xilinx_axi_emac: Add support for non processor...
2017-11-28 Siva Durga... net: xilinx_axi_emac: Read dma address using fdtdec_get...
2017-11-28 Siva Durga... net: xilinx_axi_emac: Use wait_for_bit instead of while...
2017-11-28 Michal Simekarm64: zynqmp: Add revision to identification string
2017-11-28 Shubhrajyoti... arm64: zynqmp: Enable watchdog by default
2017-11-28 Michal Simekarm64: zynqmp: Add note about si5328 interrupt
2017-11-28 Anurag Kumar... arm64: zynqmp: usb: Correct IOMMU node for making SMMU...
2017-11-28 Michal Simekarm64: zynqmp: Remove clock setting from dtsi
2017-11-28 Anurag Kumar... arm64: zynqmp: Uncomment snps,quirk-frame-length-adjust...
2017-11-28 Manish Naraniarm64: zynqmp: Add USB OTG interrupts support in dt
2017-11-28 Manish Naraniarm64: zynqmp: Enabled CCI support for USB
2017-11-28 Anurag Kumar... arm64: zynqmp: Add support reading SoC revision using...
2017-11-28 Michal Simekarm64: zynqmp: Move nodes which have no reg property...
2017-11-28 Michal Simekarm64: zynqmp: dt: Add AMS node
2017-11-28 Manish Naraniarm64: zynqmp: sdhci: set host quirk2 for no 1.8V suppo...
2017-11-28 Anurag Kumar... arm64: zynqmp: Use reset controller framework for asser...
2017-11-28 Anurag Kumar... arm64: zynqmp: Add reset-controller support in serdes...
2017-11-28 Michal Simekarm64: zynqmp: Remove tx_termination_fix detection...
2017-11-28 Nava kishore... arm64: zynqmp: Add support for zynqmp nvmem firmware...
2017-11-28 Michal Simekarm64: zynqmp: Add support for zcu102 1.0 rev
2017-11-28 Michal Simekarm64: zynqmp: Update device tree for pinmux
2017-11-28 Michal Simekarm64: zynqmp: Remove local-mac-address from dtsi file
2017-11-28 Michal Simekarm64: zynqmp: Use SPDX license with dc4
2017-11-28 Michal Simekarm64: zynqmp: Remove leading 0s from mtd table for...
2017-11-28 Michal Simekarm64: zynqmp: Add missing alias for gem0 for ep108
2017-11-28 Bharat Kumar... arm64: zynqmp: zcu102: Modifying GTR lane-0 to PCIe
2017-11-28 Chirag Parekharm64: zynqmp: Update device tree for gpio
2017-11-28 Michal Simekarm64: zynqmp: Add revB string to compatible string
2017-11-28 Michal Simekarm64: zynqmp: Use revision in dts file description
2017-11-28 Jyotheeswar... arm64: zynqmp: PM: Specify power domains for DP related...
2017-11-28 Naga Sureshkumar... arm64: zynqmp: disable smmu
2017-11-28 Nava kishore... arm64: zynqmp: rtc: Add calibration
2017-11-28 Anurag Kumar... arm64: zynqmp: Add SMMU support for SATA IP
2017-11-28 Rob Herringarm64: dts: xilinx: fix PCI bus dtc warnings
2017-11-28 Michal Simekarm64: zynqmp: Add missing gpio property to dtsi
2017-11-28 Hyun Kwonarm64: zynqmp: Update the GPU address size
2017-11-28 Madhurkiran... arm64: zynqmp: Add clock name for GPU
2017-11-28 Nava kishore... arm64: zynqmp: Label whole PL part as fpga_full region
2017-11-28 Michal Simekarm64: zynqmp: Fix broken architected timer interrupt...
2017-11-28 Soren Brinkmannarm64: zynqmp: PM: Add IRQ
2017-11-28 Jolly Shaharm64: zynqmp: Reduced min-residency time for idle...
2017-11-28 Jyotheeswar... arm64: zynqmp: DT: Fix typo in idle-states node definition
2017-11-28 Shubhrajyoti... arm64: zynqmp: Update the OPPs for cpu freq
2017-11-28 Michal Simekarm64: zynqmp: Add references to cpu nodes
2017-11-28 Michal Simekarm64: zynqmp: Wire QSPI boot mode for SPL
2017-11-28 Michal Simekarm64: zynqmp: Enable debug uart for zc1751 dc5
2017-11-28 Michal Simekarm64: zynqmp: Add new ID for RFSoC
2017-11-28 Michal Simekarm64: zynqmp: Add support for CG/EG/EV device detection
2017-11-28 Michal Simekarm64: zynqmp: Use u32 type instead of uint32_t
2017-11-28 Michal Simekarm64: zynqmp: Add SD1 level shifter mode to alternativ...
2017-11-28 Siva Durga... arm64: zynqmp: Enable config DEFINE_TCM_OCM_MMAP if...
2017-11-28 Michal Simektools: mkimage: Extend mkimage to also include pmufw
2017-11-28 Siva Durga... arm64: zynqmp: Provide a Kconfig option to use specifie...
2017-11-28 Siva Durga... arm64: zynqmp: mp: Correct the R5 release sequence
2017-11-28 Michal Simekarm64: zynqmp: Remove slcr with mio status pin detection
2017-11-28 Michal Simekata: Fix ahci wording
2017-11-28 Michal Simekarm: zynq: Add mini u-boot configuration for zynq
2017-11-28 Michal Simekarm: zynq: Sort dts names
2017-11-28 Michal Simekarm: zynq: Move ZYNQ_SERIAL to Kconfig
2017-11-28 Michal Simekarm: zynq: Enable FPGA/FPGA_XILINX via Kconfig
2017-11-28 Michal Simekarm: zynq: Return value from fdtdec_setup_memory_banksi...
2017-11-28 Michal Simekarm: zynq: Add board support for cc108
2017-11-28 Michal Simekarm: zynq: Enable qspi for zc770_xm013
2017-11-28 Michal Simekarm: zynq: Enable MACRONIX flash for zc702/zc706/zc770...
2017-11-28 Michal Simekarm: zynq: Enable debug console on zc770 xm010 by default
2017-11-28 Michal Simekarm: zynq: Enable bootz command for Xilinx platforms
2017-11-28 Michal Simekarm: zynq: Sync location of DT properties with Linux
2017-11-28 Michal Simekarm: zynq: Remove empty ifdef env structures from confi...
2017-11-28 Sai Pavan Bodduarm: zynq: Add device-type property for zynq ethernet...
2017-11-28 Chirag Parekharm: zynq: Add SCL & SDA GPIO entries for recovery
2017-11-28 Jeff Westfahlmtd: nand: zynq: Add a config option to use 1st stage...
2017-11-28 Tom McLeodarm: zynq: Add support for SYZYGY Hub board
2017-11-28 Heinrich Schuchardtarm64: zynqmp: remove unnecessary logical constraint
2017-11-28 Simon Glasstest: Correct operation when tests pass
2017-11-28 Tom Rinispl: TI: Do not default to SPL_FIT_IMAGE_TINY being...
2017-11-27 Tom RiniMerge git://www.denx.de/git/u-boot-imx
2017-11-27 Jagan Tekiconfigs: icore-rqs: Enable falcon mode
2017-11-27 Jagan Tekiengicam: imx6q: Return mmc dev 0 for icore
2017-11-27 Jagan Tekii.MX6: engicam: Add imx6q/imx6ul boards for existing...
2017-11-27 Jagan Tekiboard: icore-rqs: Fix mmc get env device
2017-11-27 Jagan Tekii.MX6UL: icore: Add SPL_OF_CONTROL support
2017-11-27 Jagan Tekipinctrl: imx6ul: Fix pinctrl data overlapped with DT...
2017-11-27 Jagan Tekii.MX6Q: icore: Add SPL_OF_CONTROL support
2017-11-27 Jagan Tekii.MX6Q: icorem6: Move spl load fit to common/spl
2017-11-27 Jagan Tekii.MX6: engicam: Move set_fdt_file to common
2017-11-27 Fabio Estevammx6sxsabresd: Use PARTUUID to specify the rootfs location
2017-11-27 Fabio Estevamimx: Remove boolean parameter from wdog powerdown function
2017-11-27 Fabio Estevamimx: Also clear powerdown enable bit for WDOG3 on i...
next