From c566439c9bf3cf2b4e5e5a059332c64199d97611 Mon Sep 17 00:00:00 2001 From: INAGAKI Hiroshi Date: Sat, 8 Dec 2018 15:18:17 +0900 Subject: [PATCH] ath79: add support for NEC Aterm WG800HP MIME-Version: 1.0 Content-Type: text/plain; charset=utf8 Content-Transfer-Encoding: 8bit NEC Aterm WG800HP is a 2.4/5 GHz band 11ac router, based on Qualcomm Atheros QCA9563. Specification: - Qualcomm Atheros QCA9563 - 64 MB of RAM (DDR2) - 8 MB of Flash (SPI-NOR) - 2.4/5 GHz wifi - 2.4 GHz: 2T2R (SoC internal) - 5 GHz: 1T1R (QCA9887) - 4x 10/100/1000 Mbps Ethernet - 8x LEDs, 3x keys (2x buttons, 1x slide-switch) - UART through-hole on PCB (J2) - Vcc, GND, NC, TX, RX from SoC side - 115200n8 Flash instruction using factory image: 1. Connect the computer to the LAN port on WG800HP 2. Connect power cable to WG800HP and turn on it 3. Access to "http://192.168.10.1/" and open firmware update page ("ファームウェア更新") 4. Select the OpenWrt factory image and click update ("更新") button 5. Wait ~150 seconds to complete flashing Signed-off-by: INAGAKI Hiroshi --- .../ath79/base-files/etc/board.d/02_network | 8 + .../etc/hotplug.d/firmware/10-ath9k-eeprom | 4 + .../etc/hotplug.d/firmware/11-ath10k-caldata | 4 + .../linux/ath79/dts/qca9563_nec_wg800hp.dts | 188 ++++++++++++++++++ target/linux/ath79/image/generic.mk | 23 +++ 5 files changed, 227 insertions(+) create mode 100644 target/linux/ath79/dts/qca9563_nec_wg800hp.dts diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 1d6cd4e774..35eff1c8f8 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -89,6 +89,10 @@ ath79_setup_interfaces() glinet,gl-x750) ucidef_set_interfaces_lan_wan "eth1" "eth0" ;; + nec,wg800hp) + ucidef_add_switch "switch0" \ + "0@eth0" "2:lan" "3:lan" "4:lan" "1:wan" + ;; netgear,wndr3700|\ netgear,wndr3700v2|\ netgear,wndr3800) @@ -238,6 +242,10 @@ ath79_setup_macs() lan_mac=$(mtd_get_mac_ascii u-boot-env ethaddr) wan_mac=$(mtd_get_mac_ascii u-boot-env wanaddr) ;; + nec,wg800hp) + lan_mac=$(mtd_get_mac_text board_data 640) + wan_mac=$(mtd_get_mac_text board_data 1152) + ;; netgear,wndr3700|\ netgear,wndr3700v2|\ netgear,wndr3800) diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index bf61ecf5dd..f6ff582150 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -111,6 +111,10 @@ case "$FIRMWARE" in ath9k_eeprom_extract "art" 4096 1088 ath9k_patch_fw_mac $(mtd_get_mac_ascii u-boot-env ethaddr) 2 ;; + nec,wg800hp) + ath9k_eeprom_extract "art" 4096 1088 + ath9k_patch_fw_mac $(mtd_get_mac_text board_data 1664) 2 + ;; *) ath9k_eeprom_die "board $board is not supported yet" ;; diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index 9ecda22244..fbe70b8b5c 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -96,6 +96,10 @@ case "$FIRMWARE" in ath10kcal_extract "art" 20480 2116 ath10kcal_patch_mac $(macaddr_add $(mtd_get_mac_ascii u-boot-env ethaddr) +1) ;; + nec,wg800hp) + ath10kcal_extract "art" 20480 2116 + ath10kcal_patch_mac_crc $(mtd_get_mac_text board_data 2176) + ;; ocedo,koala) ath10kcal_extract "art" 20480 2116 ath10kcal_patch_mac $(mtd_get_mac_binary art 12) diff --git a/target/linux/ath79/dts/qca9563_nec_wg800hp.dts b/target/linux/ath79/dts/qca9563_nec_wg800hp.dts new file mode 100644 index 0000000000..9cba99b6a6 --- /dev/null +++ b/target/linux/ath79/dts/qca9563_nec_wg800hp.dts @@ -0,0 +1,188 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca956x.dtsi" + +/ { + model = "NEC Aterm WG800HP"; + compatible = "nec,wg800hp", "qca,qca9563"; + + chosen { + bootargs = "console=ttyS0,115200n8"; + }; + + aliases { + led-boot = &power_green; + led-failsafe = &power_red; + led-running = &power_green; + led-upgrade = &power_green; + }; + + leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&jtag_disable_pins>; + + wlan2g_red { + label = "wg800hp:red:wlan2g"; + gpios = <&gpio 6 GPIO_ACTIVE_LOW>; + }; + + active_red { + label = "wg800hp:red:active"; + gpios = <&gpio 7 GPIO_ACTIVE_LOW>; + }; + + active_green { + label = "wg800hp:green:active"; + gpios = <&gpio 8 GPIO_ACTIVE_LOW>; + }; + + power_red: power_red { + label = "wg800hp:red:power"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + power_green: power_green { + label = "wg800hp:green:power"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + wlan5g_red { + label = "wg800hp:red:wlan5g"; + gpios = <&gpio 16 GPIO_ACTIVE_HIGH>; + }; + + wlan5g_green { + label = "wg800hp:green:wlan5g"; + gpios = <&gpio 17 GPIO_ACTIVE_HIGH>; + linux,default-trigger = "phy0tpt"; + }; + + wlan2g_green { + label = "wg800hp:green:wlan2g"; + gpios = <&gpio 19 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy1tpt"; + }; + }; + + keys { + compatible = "gpio-keys"; + + br { + label = "br"; + gpios = <&gpio 1 GPIO_ACTIVE_LOW>; + linux,code = ; + linux,input-type = ; + debounce-interval = <60>; + }; + + reset { + label = "reset"; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + + wps { + label = "wps"; + gpios = <&gpio 5 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + }; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x040000>; + read-only; + }; + + partition@40000 { + label = "u-boot-env"; + reg = <0x040000 0x010000>; + read-only; + }; + + partition@50000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x050000 0x6f0000>; + }; + + partition@740000 { + label = "user_data"; + reg = <0x740000 0x0a0000>; + read-only; + }; + + partition@7e0000 { + label = "board_data"; + reg = <0x7e0000 0x010000>; + read-only; + }; + + art: partition@7f0000 { + label = "art"; + reg = <0x7f0000 0x010000>; + read-only; + }; + }; + }; +}; + +&mdio0 { + status = "okay"; + + phy0: ethernet-phy@0 { + reg = <0>; + + qca,ar8327-initvals = < + 0x04 0x00000080 /* PORT0 PAD MODE CTRL */ + 0x50 0xcc35cc35 /* LED_CTRL0 */ + 0x54 0xca35ca35 /* LED_CTRL1 */ + 0x58 0xc935c935 /* LED_CTRL2 */ + 0x5c 0x03ffff00 /* LED_CTRL3 */ + 0x7c 0x0000007e /* PORT0_STATUS */ + >; + }; +}; + +ð0 { + status = "okay"; + + phy-mode = "sgmii"; + phy-handle = <&phy0>; +}; + +&pcie { + status = "okay"; +}; + +&uart { + status = "okay"; +}; + +&wmac { + status = "okay"; + qca,no-eeprom; +}; diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index c6cecc20d3..badfa7cbab 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -43,6 +43,16 @@ define Build/elecom-header endef +define Build/nec-fw + ( stat -c%s $@ | tr -d "\n" | dd bs=16 count=1 conv=sync; ) >> $@ + ( \ + echo -n -e "$(1)" | dd bs=16 count=1 conv=sync; \ + echo -n "0.0.00" | dd bs=16 count=1 conv=sync; \ + dd if=$@; \ + ) > $@.new + mv $@.new $@ +endef + define Device/avm_fritz300e ATH_SOC := ar7242 DEVICE_TITLE := AVM FRITZ!WLAN Repeater 300E @@ -262,6 +272,19 @@ define Device/iodata_wn-ag300dgr endef TARGET_DEVICES += iodata_wn-ag300dgr +define Device/nec_wg800hp + ATH_SOC := qca9563 + DEVICE_TITLE := NEC Aterm WG800HP + IMAGE_SIZE := 7104k + IMAGES += factory.bin + IMAGE/factory.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | \ + append-rootfs | pad-rootfs | check-size $$$$(IMAGE_SIZE) | \ + xor-image -p 6A57190601121E4C004C1E1201061957 -x | \ + nec-fw LASER_ATERM + DEVICE_PACKAGES := kmod-ath10k-ct ath10k-firmware-qca9887-ct-htt +endef +TARGET_DEVICES += nec_wg800hp + define Device/ocedo_koala ATH_SOC := qca9558 DEVICE_TITLE := OCEDO Koala -- 2.30.2