From c2d1c32d1ef7f2797aa424a6c94d143e9ddaddc8 Mon Sep 17 00:00:00 2001 From: Christian Lamparter Date: Mon, 13 Mar 2023 22:49:50 +0100 Subject: [PATCH] lantiq: xrx200: convert FritzBox 7360v2's wifi to nvmem this was thoroughly tested (warm and cold boots). on a real 7360v2. This is because there have been documented hick-ups with other lantiq devices that need the owl-loader too. It's likely that the 7360(sl) could be converted in the same way as well. However the 7362sl uses a reversed caldata format, so the "qca,no-eeprom" stays in place. The patch also moves the urloader nvmem partition definition into the partition section. Signed-off-by: Christian Lamparter --- .../boot/dts/lantiq/vr9_avm_fritz7360-v2.dts | 24 ++++++++++++------- .../boot/dts/lantiq/vr9_avm_fritz736x.dtsi | 2 +- .../etc/hotplug.d/firmware/12-ath9k-eeprom | 3 +-- 3 files changed, 18 insertions(+), 11 deletions(-) diff --git a/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz7360-v2.dts b/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz7360-v2.dts index 063d6dca5e..a30746cde2 100644 --- a/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz7360-v2.dts +++ b/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz7360-v2.dts @@ -42,6 +42,18 @@ label = "urlader"; reg = <0x00000 0x20000>; read-only; + + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + + cal_urlader_985: cal@985 { + reg = <0x985 0x440>; + }; + + macaddr_urlader_a91: macaddr@a91 { + reg = <0xa91 0x6>; + }; }; partition@20000 { @@ -78,12 +90,8 @@ reset-gpios = <&gpio 44 GPIO_ACTIVE_LOW>; }; -&urlader { - compatible = "nvmem-cells"; - #address-cells = <1>; - #size-cells = <1>; - - macaddr_urlader_a91: macaddr@a91 { - reg = <0xa91 0x6>; - }; +&wifi { + /delete-property/ qca,no-eeprom; + nvmem-cells = <&cal_urlader_985>; + nvmem-cell-names = "calibration"; }; diff --git a/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz736x.dtsi b/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz736x.dtsi index 73f6e152bf..7324127d2a 100644 --- a/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz736x.dtsi +++ b/target/linux/lantiq/files/arch/mips/boot/dts/lantiq/vr9_avm_fritz736x.dtsi @@ -151,7 +151,7 @@ #address-cells = <2>; device_type = "pci"; - wifi@168c,002e { + wifi: wifi@168c,002e { compatible = "pci168c,002e"; reg = <0 0 0 0 0>; qca,no-eeprom; /* load from ath9k-eeprom-pci-0000:01:00.0.bin */ diff --git a/target/linux/lantiq/xrx200/base-files/etc/hotplug.d/firmware/12-ath9k-eeprom b/target/linux/lantiq/xrx200/base-files/etc/hotplug.d/firmware/12-ath9k-eeprom index c6bacb8d3c..eefc39b30b 100644 --- a/target/linux/lantiq/xrx200/base-files/etc/hotplug.d/firmware/12-ath9k-eeprom +++ b/target/linux/lantiq/xrx200/base-files/etc/hotplug.d/firmware/12-ath9k-eeprom @@ -19,8 +19,7 @@ case "$FIRMWARE" in avm,fritz3390) caldata_extract_reverse "urlader" 0x2546 0x440 ;; - avm,fritz7360sl|\ - avm,fritz7360-v2) + avm,fritz7360sl) caldata_extract "urlader" 0x985 0x1000 ;; avm,fritz7412|\ -- 2.30.2