From c29641f71834393836b969180013cb95c8ce8576 Mon Sep 17 00:00:00 2001 From: Lech Perczak Date: Mon, 23 May 2022 20:37:47 +0200 Subject: [PATCH] ath79: ZTE MF286[,A,R]: use GPIO19 as ath9k LED With the pinctrl configuration set properly by the previous commit, the LED stays lit regardless of status of 2.4GHz radio, even if 5GHz radio is disabled. Map GPIO19 as LED for ath9k, this way the LED will show activity for both bands, as it is bound by logical AND with output of ath10k-phy0 LED. This works well because during management traffic, phy*tpt triggers typically cause LEDs to blink in unison. Link: Signed-off-by: Lech Perczak (cherry picked from commit 5ca45e0a21ee1bdafd3652e7e91a761a9cd0c838) --- target/linux/ath79/dts/qca9563_zte_mf286.dtsi | 21 +++++++------------ 1 file changed, 7 insertions(+), 14 deletions(-) diff --git a/target/linux/ath79/dts/qca9563_zte_mf286.dtsi b/target/linux/ath79/dts/qca9563_zte_mf286.dtsi index f7cbbb85bd..76dd7b6be6 100644 --- a/target/linux/ath79/dts/qca9563_zte_mf286.dtsi +++ b/target/linux/ath79/dts/qca9563_zte_mf286.dtsi @@ -30,6 +30,13 @@ gpios = <&gpio 7 GPIO_ACTIVE_LOW>; default-state = "on"; }; + + led-1 { + function = LED_FUNCTION_WLAN; + color = ; + gpios = <&gpio 19 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy1tpt"; + }; }; keys { @@ -66,20 +73,6 @@ }; }; -&gpio { - /* GPIO19 is used as a mask to enable WLAN LED - * in stock firmware, which is controlled directly - * by 5GHz Wi-Fi chip, which currently is inactive - * in OpenWrt - */ - led-wlan { - gpio-hog; - gpios = <19 GPIO_ACTIVE_LOW>; - output-high; - line-name = "led:wlan"; - }; -}; - &spi { status = "okay"; -- 2.30.2