From bc1b50309ce19bb2ccb1340fa83ab56ca6da8f96 Mon Sep 17 00:00:00 2001 From: Ganesh Goudar Date: Fri, 13 Jul 2018 17:56:55 +0530 Subject: [PATCH] cxgb4: do not return DUPLEX_UNKNOWN when link is down We were returning DUPLEX_UNKNOWN in get_link_ksettings() when the link was down. Unfortunately, this causes a problem when "ethtool -s autoneg on" is issued for a link which is down because the ethtool code first reads the settings and then reapplies them with only the changes provided on the command line. Which results in us diving into set_link_ksettings() with DUPLEX_UNKNOWN which is not DUPLEX_FULL, so set_link_ksettings() throws an -EINVAL error. do not return DUPLEX_UNKNOWN to fix the issue. Signed-off-by: Casey Leedom Signed-off-by: Ganesh Goudar Signed-off-by: David S. Miller --- drivers/net/ethernet/chelsio/cxgb4/cxgb4_ethtool.c | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-) diff --git a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_ethtool.c b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_ethtool.c index a14a290a56ee..d07230c892a5 100644 --- a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_ethtool.c +++ b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_ethtool.c @@ -628,13 +628,10 @@ static int get_link_ksettings(struct net_device *dev, fw_caps_to_lmm(pi->port_type, pi->link_cfg.lpacaps, link_ksettings->link_modes.lp_advertising); - if (netif_carrier_ok(dev)) { - base->speed = pi->link_cfg.speed; - base->duplex = DUPLEX_FULL; - } else { - base->speed = SPEED_UNKNOWN; - base->duplex = DUPLEX_UNKNOWN; - } + base->speed = (netif_carrier_ok(dev) + ? pi->link_cfg.speed + : SPEED_UNKNOWN); + base->duplex = DUPLEX_FULL; if (pi->link_cfg.fc & PAUSE_RX) { if (pi->link_cfg.fc & PAUSE_TX) { -- 2.30.2