From a9f6309585cbefa4a7f08c9017ca482c3222323a Mon Sep 17 00:00:00 2001 From: Florian Fainelli Date: Fri, 22 Aug 2014 18:55:44 -0700 Subject: [PATCH] net: phy: allow phy_init_eee() to work with internal PHYs Internal PHYs do not have any specific phy_interface_t defined because they are within an Ethernet MAC or a larger IC, they will fail the early check in phy_init_eee(). Allow these PHYs to proceed with EEE initialization and report error/success by checking the standard C45 EEE-related registers. Signed-off-by: Florian Fainelli Signed-off-by: David S. Miller --- drivers/net/phy/phy.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c index e7a5893f32ff..932190e04d08 100644 --- a/drivers/net/phy/phy.c +++ b/drivers/net/phy/phy.c @@ -1019,12 +1019,14 @@ int phy_init_eee(struct phy_device *phydev, bool clk_stop_enable) { /* According to 802.3az,the EEE is supported only in full duplex-mode. * Also EEE feature is active when core is operating with MII, GMII - * or RGMII. + * or RGMII. Internal PHYs are also allowed to proceed and should + * return an error if they do not support EEE. */ if ((phydev->duplex == DUPLEX_FULL) && ((phydev->interface == PHY_INTERFACE_MODE_MII) || (phydev->interface == PHY_INTERFACE_MODE_GMII) || - (phydev->interface == PHY_INTERFACE_MODE_RGMII))) { + (phydev->interface == PHY_INTERFACE_MODE_RGMII) || + phy_is_internal(phydev))) { int eee_lp, eee_cap, eee_adv; u32 lp, cap, adv; int status; -- 2.30.2