From 892aa01df2ad67237f213c8f9d9b491e908aa910 Mon Sep 17 00:00:00 2001 From: Sjoerd Simons Date: Fri, 11 Sep 2015 22:25:48 +0200 Subject: [PATCH] net: stmmac: Use msleep rather then udelay for reset delay The reset delays used for stmmac are in the order of 10ms to 1 second, which is far too long for udelay usage, so switch to using msleep. Practically this fixes the PHY not being reliably detected in some cases as udelay wouldn't actually delay for long enough to let the phy reliably be reset. Signed-off-by: Sjoerd Simons Signed-off-by: David S. Miller --- drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 11 ++++++++--- 1 file changed, 8 insertions(+), 3 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c index b735fa22ac95..ebf6abc4853f 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c @@ -161,11 +161,16 @@ int stmmac_mdio_reset(struct mii_bus *bus) if (!gpio_request(reset_gpio, "mdio-reset")) { gpio_direction_output(reset_gpio, active_low ? 1 : 0); - udelay(data->delays[0]); + if (data->delays[0]) + msleep(DIV_ROUND_UP(data->delays[0], 1000)); + gpio_set_value(reset_gpio, active_low ? 0 : 1); - udelay(data->delays[1]); + if (data->delays[1]) + msleep(DIV_ROUND_UP(data->delays[1], 1000)); + gpio_set_value(reset_gpio, active_low ? 1 : 0); - udelay(data->delays[2]); + if (data->delays[2]) + msleep(DIV_ROUND_UP(data->delays[2], 1000)); } } #endif -- 2.30.2