From 882a6116d3d6394dd109350287067accebbf6114 Mon Sep 17 00:00:00 2001 From: Shiji Yang Date: Sun, 4 Apr 2021 11:55:41 +0800 Subject: [PATCH] ramips: improve pinctrl for Youku YK-L1 1. rename led pin "air" to a more common name "wlan" and use "phy0tpt" to trigger it. 2. led "wan" can be triggered by ethernet pinctrl by default so just drop it. Signed-off-by: Shiji Yang --- target/linux/ramips/dts/mt7620a_youku_yk1.dts | 16 ++++------------ .../ramips/mt7620/base-files/etc/board.d/01_leds | 4 ---- 2 files changed, 4 insertions(+), 16 deletions(-) diff --git a/target/linux/ramips/dts/mt7620a_youku_yk1.dts b/target/linux/ramips/dts/mt7620a_youku_yk1.dts index 3b84b07b8b..71fd1d12c0 100644 --- a/target/linux/ramips/dts/mt7620a_youku_yk1.dts +++ b/target/linux/ramips/dts/mt7620a_youku_yk1.dts @@ -17,14 +17,10 @@ leds { compatible = "gpio-leds"; - wan { - label = "blue:wan"; - gpios = <&gpio2 4 GPIO_ACTIVE_LOW>; - }; - - air { - label = "blue:air"; + wlan { + label = "blue:wlan"; gpios = <&gpio3 0 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; }; usb { @@ -55,10 +51,6 @@ status = "okay"; }; -&gpio2 { - status = "okay"; -}; - &gpio3 { status = "okay"; }; @@ -106,7 +98,7 @@ &state_default { default { - groups = "i2c", "rgmii1", "ephy", "wled"; + groups = "i2c", "rgmii1", "wled"; function = "gpio"; }; }; diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds index 40d322685a..bbedbe9f0d 100644 --- a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds @@ -194,10 +194,6 @@ tplink,archer-mr200) tplink,re200-v1) ucidef_set_led_netdev "lan" "lan" "green:lan" "eth0" ;; -youku,yk1) - ucidef_set_led_switch "wan" "wan" "blue:wan" "switch0" "0x10" - ucidef_set_led_netdev "wifi_led" "wifi" "blue:air" "wlan0" - ;; zbtlink,zbt-ape522ii) ucidef_set_led_netdev "wlan2g4" "wlan1-link" "green:wlan2g4" "wlan1" ucidef_set_led_netdev "sys1" "wlan1" "green:sys1" "wlan1" "tx rx" -- 2.30.2