From 75dad2520fc37345075498e9c5aa1355b4993dbc Mon Sep 17 00:00:00 2001 From: Benedikt Spranger Date: Fri, 28 Jun 2019 18:58:11 +0200 Subject: [PATCH] net: dsa: b53: Disable all ports on setup A b53 device may configured through an external EEPROM like the switch device on the Lamobo R1 router board. The configuration of a port may therefore differ from the reset configuration of the switch. The switch configuration reported by the DSA subsystem is different until the port is configured by DSA i.e. a port can be active, while the DSA subsystem reports the port is inactive. Disable all ports and not only the unused ones to put all ports into a well defined state. Signed-off-by: Benedikt Spranger Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller --- drivers/net/dsa/b53/b53_common.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/dsa/b53/b53_common.c b/drivers/net/dsa/b53/b53_common.c index c8040ecf4425..907af62846ba 100644 --- a/drivers/net/dsa/b53/b53_common.c +++ b/drivers/net/dsa/b53/b53_common.c @@ -955,13 +955,13 @@ static int b53_setup(struct dsa_switch *ds) if (ret) dev_err(ds->dev, "failed to apply configuration\n"); - /* Configure IMP/CPU port, disable unused ports. Enabled + /* Configure IMP/CPU port, disable all other ports. Enabled * ports will be configured with .port_enable */ for (port = 0; port < dev->num_ports; port++) { if (dsa_is_cpu_port(ds, port)) b53_enable_cpu_port(dev, port); - else if (dsa_is_unused_port(ds, port)) + else b53_disable_port(ds, port); } -- 2.30.2