From 5dfa89be9900819a2796f3ff9c3f395735035f3c Mon Sep 17 00:00:00 2001 From: Piotr Dymacz Date: Fri, 17 Sep 2021 14:52:04 +0200 Subject: [PATCH] ath79: add support for Netgear R6100 Netgear R6100 is a dual-band Wi-Fi 5 (AC1200) router based on Qualcomm Atheros (AR9344 + QCA9882) platform. Support for this device was first introduced in 15f6f67d18 (ar71xx). FCC ID: PY312400225. Specifications: - Atheros AR9344 (560 MHz) - 128 MB of RAM (DDR2) - 128 MB of flash (parallel NAND) - 2T2R 2.4 GHz Wi-Fi (AR9344) - 2T2R 5 GHz Wi-Fi (QCA9882) - 5x 10/100 Mbps Ethernet (AR9344) - 4x internal antenna - 1x USB 2.0 (GPIO-controlled power) - 6x LED, 3x button (reset, Wi-Fi, WPS) - UART (4-pin, 2.54 mm pitch) header on PCB - 1x mechanical power switch - DC jack for main power input (12 V) WARNING: sysupgrade from older stable releases is not possible, fresh installation (via vendor's GUI or TFTP based recovery) is required. Reason for that is increased kernel partition size. Installation: Use the 'factory' image under vendor's GUI or via TFTP U-Boot recovery. You can use the 'nmrpflash' tool at a boot time, before kernel is loaded or start it manually by pressing the 'reset' button for ~20 seconds from powering up the device (U-Boot will start TFTP server on 192.168.1.1, use TFTP client to send the image). Signed-off-by: Enrico Mioso Signed-off-by: Zoltan HERPAI Signed-off-by: Michael Pratt Signed-off-by: Piotr Dymacz --- .../linux/ath79/dts/ar9344_netgear_r6100.dts | 231 ++++++++++++++++++ target/linux/ath79/image/nand.mk | 11 + .../ath79/nand/base-files/etc/board.d/01_leds | 3 + .../nand/base-files/etc/board.d/02_network | 5 + .../etc/hotplug.d/firmware/11-ath10k-caldata | 3 + 5 files changed, 253 insertions(+) create mode 100644 target/linux/ath79/dts/ar9344_netgear_r6100.dts diff --git a/target/linux/ath79/dts/ar9344_netgear_r6100.dts b/target/linux/ath79/dts/ar9344_netgear_r6100.dts new file mode 100644 index 00000000000..80951d62490 --- /dev/null +++ b/target/linux/ath79/dts/ar9344_netgear_r6100.dts @@ -0,0 +1,231 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "ar9344.dtsi" + +#include +#include + +/ { + model = "Netgear R6100"; + compatible = "netgear,r6100", "qca,ar9344"; + + aliases { + label-mac-device = ð0; + led-boot = &led_power_green; + led-failsafe = &led_power_amber; + led-running = &led_power_green; + led-upgrade = &led_power_green; + }; + + gpio-export { + compatible = "gpio-export"; + #size-cells = <0>; + + usb-power { + gpio-export,name = "usb-power"; + gpio-export,output = <1>; + gpios = <&gpio 16 GPIO_ACTIVE_HIGH>; + }; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + linux,code = ; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + rfkill { + label = "rfkill"; + linux,code = ; + gpios = <&gpio 1 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + wps { + label = "wps"; + linux,code = ; + gpios = <&gpio 3 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; + + leds { + compatible = "gpio-leds"; + + led_power_amber: power_amber { + label = "amber:power"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + led_power_green: power_green { + label = "green:power"; + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; + }; + + usb { + label = "blue:usb"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + trigger-sources = <&hub_port>; + linux,default-trigger = "usbport"; + }; + + wan_amber { + label = "amber:wan"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + + wan_green { + label = "green:wan"; + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + }; + + wlan { + label = "blue:wlan"; + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy1tpt"; + }; + }; +}; + +ð0 { + status = "okay"; + + phy-handle = <&swphy0>; + + nvmem-cells = <&macaddr_caldata_6>; + nvmem-cell-names = "mac-address"; + + gmac-config { + device = <&gmac>; + switch-phy-swap = <1>; + }; +}; + +ð1 { + status = "okay"; + + nvmem-cells = <&macaddr_caldata_0>; + nvmem-cell-names = "mac-address"; +}; + +&nand { + status = "okay"; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0000000 0x0020000>; + read-only; + }; + + caldata: partition@20000 { + label = "caldata"; + reg = <0x0020000 0x0040000>; + read-only; + }; + + partition@60000 { + label = "caldata-backup"; + reg = <0x0060000 0x0040000>; + read-only; + }; + + partition@a0000 { + label = "config"; + reg = <0x00a0000 0x0080000>; + read-only; + }; + + partition@120000 { + label = "pot"; + reg = <0x0120000 0x0080000>; + read-only; + }; + + partition@1a0000 { + label = "kernel"; + reg = <0x01a0000 0x0400000>; + }; + + partition@5a0000 { + label = "ubi"; + reg = <0x05a0000 0x7560000>; + }; + + partition@7b00000 { + label = "language"; + reg = <0x7b00000 0x0200000>; + read-only; + }; + + partition@7d00000 { + label = "traffic_meter"; + reg = <0x7d00000 0x0300000>; + read-only; + }; + }; +}; + +&pcie { + status = "okay"; + + wifi@0,0,0 { + compatible = "qcom,ath10k"; + reg = <0x0000 0 0 0 0>; + + nvmem-cells = <&macaddr_caldata_c>; + nvmem-cell-names = "mac-address"; + }; +}; + +&ref { + clock-frequency = <40000000>; +}; + +&usb { + status = "okay"; + + #address-cells = <1>; + #size-cells = <0>; + + hub_port: port@1 { + reg = <1>; + #trigger-source-cells = <0>; + }; +}; + +&usb_phy { + status = "okay"; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&caldata 0x1000>; +}; + +&caldata { + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + + macaddr_caldata_0: macaddr@0 { + reg = <0x0 0x6>; + }; + + macaddr_caldata_6: macaddr@6 { + reg = <0x6 0x6>; + }; + + macaddr_caldata_c: macaddr@c { + reg = <0xc 0x6>; + }; +}; diff --git a/target/linux/ath79/image/nand.mk b/target/linux/ath79/image/nand.mk index b34e796ac38..91fd7ec3014 100644 --- a/target/linux/ath79/image/nand.mk +++ b/target/linux/ath79/image/nand.mk @@ -215,6 +215,17 @@ define Device/netgear_ath79_nand UBINIZE_OPTS := -E 5 endef +define Device/netgear_r6100 + SOC := ar9344 + DEVICE_MODEL := R6100 + UIMAGE_MAGIC := 0x36303030 + NETGEAR_BOARD_ID := R6100 + NETGEAR_HW_ID := 29764434+0+128+128+2x2+2x2 + $(Device/netgear_ath79_nand) + DEVICE_PACKAGES += kmod-ath10k-ct ath10k-firmware-qca988x-ct +endef +TARGET_DEVICES += netgear_r6100 + define Device/netgear_wndr3700-v4 SOC := ar9344 DEVICE_MODEL := WNDR3700 diff --git a/target/linux/ath79/nand/base-files/etc/board.d/01_leds b/target/linux/ath79/nand/base-files/etc/board.d/01_leds index f694d07e9c4..dc7d84df957 100644 --- a/target/linux/ath79/nand/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/nand/base-files/etc/board.d/01_leds @@ -14,6 +14,9 @@ glinet,gl-ar300m-nand|\ glinet,gl-ar300m-nor) ucidef_set_led_netdev "lan" "LAN" "green:lan" "eth0" ;; +netgear,r6100) + ucidef_set_led_netdev "wan-green" "WAN (green)" "green:wan" "eth1" + ;; netgear,wndr3700-v4|\ netgear,wndr4300|\ netgear,wndr4300sw|\ diff --git a/target/linux/ath79/nand/base-files/etc/board.d/02_network b/target/linux/ath79/nand/base-files/etc/board.d/02_network index dbb9e681501..76cdab18f83 100644 --- a/target/linux/ath79/nand/base-files/etc/board.d/02_network +++ b/target/linux/ath79/nand/base-files/etc/board.d/02_network @@ -25,6 +25,11 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth0" "2:lan:2" "3:lan:1" "1:wan" ;; + netgear,r6100) + ucidef_set_interface_wan "eth1" + ucidef_add_switch "switch0" \ + "0@eth0" "1:lan:4" "2:lan:1" "3:lan:2" "4:lan:3" + ;; netgear,wndr3700-v4|\ netgear,wndr4300|\ netgear,wndr4300sw|\ diff --git a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index 71dfb161e46..03e225ddde3 100644 --- a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -23,6 +23,9 @@ case "$FIRMWARE" in caldata_extract "art" 0x5000 0x844 ath10k_patch_mac $(macaddr_add $(mtd_get_mac_binary art 0x0) 1) ;; + netgear,r6100) + caldata_extract "caldata" 0x5000 0x844 + ;; zyxel,nbg6716) caldata_extract "art" 0x5000 0x844 ath10k_patch_mac $(macaddr_add $(mtd_get_mac_ascii u-boot-env ethaddr) 1) -- 2.30.2