From 5c164646e25a5a073875c6ca346efa0d5afb6934 Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Sun, 20 May 2012 08:11:04 -0300 Subject: [PATCH] [media] bttv: Use btv->has_radio rather then the card info when registering the tuner bttv_init_card2() sets btv->has_audio to a *default* value from the tvcards array and then may update it by reading a card specific eeprom or gpio detection. After bttv_init_card2(), bttv_init_tuner() gets called, and it should clearly use the updated, dynamic has_radio value from btv->has_radio, rather then the const value in the tvcards array. This fixes the radio not working on my Hauppauge WinTV. Signed-off-by: Hans de Goede Signed-off-by: Mauro Carvalho Chehab --- drivers/media/video/bt8xx/bttv-cards.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/media/video/bt8xx/bttv-cards.c b/drivers/media/video/bt8xx/bttv-cards.c index ff2933ab705f..1c030fecbf41 100644 --- a/drivers/media/video/bt8xx/bttv-cards.c +++ b/drivers/media/video/bt8xx/bttv-cards.c @@ -3649,7 +3649,7 @@ void __devinit bttv_init_tuner(struct bttv *btv) struct tuner_setup tun_setup; /* Load tuner module before issuing tuner config call! */ - if (bttv_tvcards[btv->c.type].has_radio) + if (btv->has_radio) v4l2_i2c_new_subdev(&btv->c.v4l2_dev, &btv->c.i2c_adap, "tuner", 0, v4l2_i2c_tuner_addrs(ADDRS_RADIO)); @@ -3664,7 +3664,7 @@ void __devinit bttv_init_tuner(struct bttv *btv) tun_setup.type = btv->tuner_type; tun_setup.addr = addr; - if (bttv_tvcards[btv->c.type].has_radio) + if (btv->has_radio) tun_setup.mode_mask |= T_RADIO; bttv_call_all(btv, tuner, s_type_addr, &tun_setup); -- 2.30.2