From 526549a850bf6f549b88a271c7df9dd847e02bcf Mon Sep 17 00:00:00 2001 From: Michal Kazior Date: Fri, 12 Dec 2014 12:41:37 +0100 Subject: [PATCH] ath10k: prevent invalid ps timeout config Setting 0 ps timeout to firmware yields very poor latency and traffic issues. This is the case when multi-vif is active. Signed-off-by: Michal Kazior Signed-off-by: Kalle Valo --- drivers/net/wireless/ath/ath10k/mac.c | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 13c2bad71c21..2804952448c5 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -1105,10 +1105,12 @@ static int ath10k_mac_vif_recalc_ps_poll_count(struct ath10k_vif *arvif) static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif) { struct ath10k *ar = arvif->ar; + struct ieee80211_vif *vif = arvif->vif; struct ieee80211_conf *conf = &ar->hw->conf; enum wmi_sta_powersave_param param; enum wmi_sta_ps_mode psmode; int ret; + int ps_timeout; lockdep_assert_held(&arvif->ar->conf_mutex); @@ -1119,8 +1121,15 @@ static int ath10k_mac_vif_setup_ps(struct ath10k_vif *arvif) psmode = WMI_STA_PS_MODE_ENABLED; param = WMI_STA_PS_PARAM_INACTIVITY_TIME; + ps_timeout = conf->dynamic_ps_timeout; + if (ps_timeout == 0) { + /* Firmware doesn't like 0 */ + ps_timeout = ieee80211_tu_to_usec( + vif->bss_conf.beacon_int) / 1000; + } + ret = ath10k_wmi_set_sta_ps_param(ar, arvif->vdev_id, param, - conf->dynamic_ps_timeout); + ps_timeout); if (ret) { ath10k_warn(ar, "failed to set inactivity time for vdev %d: %i\n", arvif->vdev_id, ret); -- 2.30.2