From 4c94cb651f478e0b53f10b77033b91a5c7702740 Mon Sep 17 00:00:00 2001 From: Yoshihiro Shimoda Date: Tue, 9 Apr 2019 20:05:06 +0900 Subject: [PATCH] mmc: core: retry CMD1 in mmc_send_op_cond() even if the ocr = 0 According to eMMC specification v5.1 section 6.4.3, we should issue CMD1 repeatedly in the idle state until the eMMC is ready even if the mmc_attach_mmc() calls this function with ocr = 0. Otherwise some eMMC devices seems to enter the inactive mode after mmc_init_card() issued CMD0 when the eMMC device is busy. Signed-off-by: Yoshihiro Shimoda Reviewed-by: Wolfram Sang Signed-off-by: Ulf Hansson --- drivers/mmc/core/mmc_ops.c | 16 +++++++++++----- 1 file changed, 11 insertions(+), 5 deletions(-) diff --git a/drivers/mmc/core/mmc_ops.c b/drivers/mmc/core/mmc_ops.c index c5208fb312ae..a533cab8fccc 100644 --- a/drivers/mmc/core/mmc_ops.c +++ b/drivers/mmc/core/mmc_ops.c @@ -184,11 +184,7 @@ int mmc_send_op_cond(struct mmc_host *host, u32 ocr, u32 *rocr) if (err) break; - /* if we're just probing, do a single pass */ - if (ocr == 0) - break; - - /* otherwise wait until reset completes */ + /* wait until reset completes */ if (mmc_host_is_spi(host)) { if (!(cmd.resp[0] & R1_SPI_IDLE)) break; @@ -200,6 +196,16 @@ int mmc_send_op_cond(struct mmc_host *host, u32 ocr, u32 *rocr) err = -ETIMEDOUT; mmc_delay(10); + + /* + * According to eMMC specification v5.1 section 6.4.3, we + * should issue CMD1 repeatedly in the idle state until + * the eMMC is ready. Otherwise some eMMC devices seem to enter + * the inactive mode after mmc_init_card() issued CMD0 when + * the eMMC device is busy. + */ + if (!ocr && !mmc_host_is_spi(host)) + cmd.arg = cmd.resp[0] | BIT(30); } if (rocr && !mmc_host_is_spi(host)) -- 2.30.2