From 3a9dddea89eb2132ba919fe04cb3b44a3b1e6db7 Mon Sep 17 00:00:00 2001 From: Felix Fietkau Date: Wed, 13 Apr 2011 21:56:46 +0200 Subject: [PATCH] ath5k: disable 5 GHz support for the dualband PHY chip on dual-radio AR5312 There are two variants of AR5312 dual-band devices, one single-radio and the other one dual-radio. On the dual-radio board, the first MAC only supports 5 GHz, even though it has a dual-band PHY. The 2.4 GHz part of this phy is used in pass-through mode, connecting the second MAC with the second PHY. Disable 2.4 GHz for the first MAC on an AR5312, but only if the board configuration indicates a dual-radio device. Signed-off-by: Felix Fietkau Tested-by: Sedat Dilek Signed-off-by: John W. Linville --- drivers/net/wireless/ath/ath5k/ahb.c | 10 ++++++++++ drivers/net/wireless/ath/ath5k/attach.c | 5 +++++ drivers/net/wireless/ath/ath5k/base.h | 3 ++- 3 files changed, 17 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/ath/ath5k/ahb.c b/drivers/net/wireless/ath/ath5k/ahb.c index 1374e647f4e6..ea9982781559 100644 --- a/drivers/net/wireless/ath/ath5k/ahb.c +++ b/drivers/net/wireless/ath/ath5k/ahb.c @@ -160,6 +160,16 @@ static int ath_ahb_probe(struct platform_device *pdev) else reg |= AR5K_AR5312_ENABLE_WLAN1; __raw_writel(reg, (void __iomem *) AR5K_AR5312_ENABLE); + + /* + * On a dual-band AR5312, the multiband radio is only + * used as pass-through. Disable 2 GHz support in the + * driver for it + */ + if (to_platform_device(sc->dev)->id == 0 && + (bcfg->config->flags & (BD_WLAN0|BD_WLAN1)) == + (BD_WLAN1|BD_WLAN0)) + __set_bit(ATH_STAT_2G_DISABLED, sc->status); } ret = ath5k_init_softc(sc, &ath_ahb_bus_ops); diff --git a/drivers/net/wireless/ath/ath5k/attach.c b/drivers/net/wireless/ath/ath5k/attach.c index 326d7c84c912..1588401de3c4 100644 --- a/drivers/net/wireless/ath/ath5k/attach.c +++ b/drivers/net/wireless/ath/ath5k/attach.c @@ -313,6 +313,11 @@ int ath5k_hw_init(struct ath5k_softc *sc) goto err; } + if (test_bit(ATH_STAT_2G_DISABLED, sc->status)) { + __clear_bit(AR5K_MODE_11B, ah->ah_capabilities.cap_mode); + __clear_bit(AR5K_MODE_11G, ah->ah_capabilities.cap_mode); + } + /* Crypto settings */ common->keymax = (sc->ah->ah_version == AR5K_AR5210 ? AR5K_KEYTABLE_SIZE_5210 : AR5K_KEYTABLE_SIZE_5211); diff --git a/drivers/net/wireless/ath/ath5k/base.h b/drivers/net/wireless/ath/ath5k/base.h index 4c4e36064a3b..b294f3305011 100644 --- a/drivers/net/wireless/ath/ath5k/base.h +++ b/drivers/net/wireless/ath/ath5k/base.h @@ -193,12 +193,13 @@ struct ath5k_softc { dma_addr_t desc_daddr; /* DMA (physical) address */ size_t desc_len; /* size of TX/RX descriptors */ - DECLARE_BITMAP(status, 5); + DECLARE_BITMAP(status, 6); #define ATH_STAT_INVALID 0 /* disable hardware accesses */ #define ATH_STAT_MRRETRY 1 /* multi-rate retry support */ #define ATH_STAT_PROMISC 2 #define ATH_STAT_LEDSOFT 3 /* enable LED gpio status */ #define ATH_STAT_STARTED 4 /* opened & irqs enabled */ +#define ATH_STAT_2G_DISABLED 5 /* multiband radio without 2G */ unsigned int filter_flags; /* HW flags, AR5K_RX_FILTER_* */ struct ieee80211_channel *curchan; /* current h/w channel */ -- 2.30.2