From 36a86872964609f2596d22f323070b60b17e08ef Mon Sep 17 00:00:00 2001 From: Charles Keepax Date: Thu, 19 Nov 2015 15:45:40 +0000 Subject: [PATCH] extcon: arizona: Update DT binding documentation for jack detection Add additional bindings for both inverting the polarity of the jack detection pins and allowing the use of a second jack detection pin. Note that the second jack detection pin is hard wired in the chip so can only be enabled through the binding, rather than a pin being specified. Signed-off-by: Charles Keepax Reviewed-by: Chanwoo Choi Signed-off-by: Chanwoo Choi --- Documentation/devicetree/bindings/extcon/extcon-arizona.txt | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/Documentation/devicetree/bindings/extcon/extcon-arizona.txt b/Documentation/devicetree/bindings/extcon/extcon-arizona.txt index d6618119a9a8..7640a3502c67 100644 --- a/Documentation/devicetree/bindings/extcon/extcon-arizona.txt +++ b/Documentation/devicetree/bindings/extcon/extcon-arizona.txt @@ -14,6 +14,12 @@ Optional properties: If this node is not mentioned or if the value is unknown, then headphone detection mode is set to HPDETL. + - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack + detection. + - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for + jack detection. + - wlf,jd-invert : Invert the polarity of the jack detection switch + - wlf,micd-software-compare : Use a software comparison to determine mic presence - wlf,micd-detect-debounce : Additional software microphone detection -- 2.30.2