From: Robert Marko Date: Thu, 26 Nov 2020 12:54:34 +0000 (+0100) Subject: ipq40xx: net: ethernet: edma: use generic PHY print X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=fd033364f655f129b438fe67c87f95ef7b56fda1;p=openwrt%2Fstaging%2Fthess.git ipq40xx: net: ethernet: edma: use generic PHY print Lets use the generic upstream phy_print_status() instead of doing something similar by hand. Before: ess_edma c080000.edma: eth1: GMAC Link is up with phy_speed=1000 After: ess_edma c080000.edma eth1: Link is Up - 1Gbps/Full - flow control rx/tx Signed-off-by: Robert Marko --- diff --git a/target/linux/ipq40xx/files/drivers/net/ethernet/qualcomm/essedma/edma.c b/target/linux/ipq40xx/files/drivers/net/ethernet/qualcomm/essedma/edma.c index ecbc946de9..80db1f0acb 100644 --- a/target/linux/ipq40xx/files/drivers/net/ethernet/qualcomm/essedma/edma.c +++ b/target/linux/ipq40xx/files/drivers/net/ethernet/qualcomm/essedma/edma.c @@ -1310,7 +1310,7 @@ void edma_adjust_link(struct net_device *netdev) status = edma_check_link(adapter); if (status == __EDMA_LINKUP && adapter->link_state == __EDMA_LINKDOWN) { - dev_info(&adapter->pdev->dev, "%s: GMAC Link is up with phy_speed=%d\n", netdev->name, phydev->speed); + phy_print_status(phydev); adapter->link_state = __EDMA_LINKUP; if (adapter->edma_cinfo->is_single_phy) { ess_set_port_status_speed(adapter->edma_cinfo, phydev, @@ -1320,7 +1320,7 @@ void edma_adjust_link(struct net_device *netdev) if (netif_running(netdev)) netif_tx_wake_all_queues(netdev); } else if (status == __EDMA_LINKDOWN && adapter->link_state == __EDMA_LINKUP) { - dev_info(&adapter->pdev->dev, "%s: GMAC Link is down\n", netdev->name); + phy_print_status(phydev); adapter->link_state = __EDMA_LINKDOWN; netif_carrier_off(netdev); netif_tx_stop_all_queues(netdev);