From: Daniel González Cabanelas Date: Thu, 16 Feb 2023 22:04:20 +0000 (+0100) Subject: ipq40xx: Linksys MR8300: fix the USB port power X-Git-Tag: v23.05.0-rc1~922 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=ed64c3323590e3c9fa8b423bf37689023a7a101f;p=openwrt%2Fopenwrt.git ipq40xx: Linksys MR8300: fix the USB port power The USB port on the MR8300 randomly fails to feed bus-powered devices. This is caused by a misconfigured pinmux. The GPIO68 should be used to enable the USB power (active low), but it's inside the NAND pinmux. This GPIO pin was found in the original firmware at a startup script in both MR8300 and EA8300. Therefore apply the fix for both boards. Signed-off-by: Daniel González Cabanelas Reviewed-by: Robert Marko --- diff --git a/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-xx8300.dtsi b/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-xx8300.dtsi index db9ca1e725..141ea60442 100644 --- a/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-xx8300.dtsi +++ b/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-xx8300.dtsi @@ -100,6 +100,16 @@ status = "okay"; }; }; + + regulator-usb-vbus { + compatible = "regulator-fixed"; + regulator-name = "USB_VBUS"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + regulator-always-on; + regulator-boot-on; + gpio = <&tlmm 68 GPIO_ACTIVE_LOW>; + }; }; @@ -268,7 +278,7 @@ pins = "gpio55", "gpio56", "gpio57", "gpio60", "gpio62", "gpio63", "gpio64", "gpio65", "gpio66", - "gpio67", "gpio68", "gpio69"; + "gpio67", "gpio69"; function = "qpic"; bias-pull-down; };