From: Daniel González Cabanelas Date: Wed, 21 Jun 2023 21:14:02 +0000 (+0200) Subject: bmips: add support for Arcadyan AR7516 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=df8e4b6c2e6440bc9a31467de1739c69c328e391;p=openwrt%2Fstaging%2Fjogo.git bmips: add support for Arcadyan AR7516 The Arcadyan AR7516, AKA Orange Bright Box or EE Bright Box 1, is a wifi fast ethernet router, 2.4 GHz single band with two internal antennas. It comes with a horizontal stand black shiny casing. Newer Bright Box 1 model stands vertically, and comes with a totally different board inside, not compatible with this firmware. Hardware: - SoC: Broadcom BCM6328 - CPU: single core BMIPS4350 V7.5 @ 320Mhz - RAM: 64 MB DDR2 - Flash: 8 MB SPI NOR - Ethernet LAN: 4x 100Mbit - Wifi 2.4 GHz: Broadcom BCM43227 802.11bgn (onboard) - USB: 1x 2.0 - ADSL: yes, unsupported - Buttons: 2x - LEDs: 9x, power LED is hardware controlled - UART: yes Installation in two steps, new CFE bootloader and firmware: Install new CFE: 1. Power off the router and press the RESET button 2. Power on the router and wait some seconds 3. Release the RESET button 3. Browse to http://192.168.1.1, this web interface will offer both firmware (“Software”) upgrade and bootloader upgrade; be sure to use the bootloader section of the upload form. 4. Upload the new CFE (availabe at the wiki page) 5. Wait about a minute for flashing to finish and reboot into the new bootloader. Install OpenWrt via new CFE web UI: 1. After installing the new CFE, visit http://192.168.1.1 2. Upload the Openwrt cfe firmware 5. Wait a few minutes for it to finish Signed-off-by: Daniel González Cabanelas --- diff --git a/target/linux/bmips/bcm6328/base-files/etc/board.d/01_leds b/target/linux/bmips/bcm6328/base-files/etc/board.d/01_leds index 5e80eb34e7..b2ccc9a60e 100644 --- a/target/linux/bmips/bcm6328/base-files/etc/board.d/01_leds +++ b/target/linux/bmips/bcm6328/base-files/etc/board.d/01_leds @@ -6,6 +6,10 @@ board_config_update case "$(board_name)" in +arcadyan,ar7516) + ucidef_set_led_netdev "wan" "WAN" "green:wan" "wan" + ucidef_set_led_netdev "wlan0" "WiFi" "green:wifi" "phy0-ap0" + ;; nucom,r5010unv2 |\ sercomm,ad1018) ucidef_set_led_usbport "usb" "USB" "green:usb" "usb1-port1" "usb2-port1" diff --git a/target/linux/bmips/bcm6328/base-files/etc/board.d/02_network b/target/linux/bmips/bcm6328/base-files/etc/board.d/02_network index bfedad9e45..391e38c4dc 100644 --- a/target/linux/bmips/bcm6328/base-files/etc/board.d/02_network +++ b/target/linux/bmips/bcm6328/base-files/etc/board.d/02_network @@ -5,6 +5,10 @@ board_config_update case "$(board_name)" in +arcadyan,ar7516) + ucidef_set_bridge_device switch + ucidef_set_interfaces_lan_wan "lan1 lan2 lan3" "wan" + ;; comtrend,ar-5381u |\ comtrend,ar-5387un |\ nucom,r5010unv2) diff --git a/target/linux/bmips/bcm6328/base-files/etc/uci-defaults/09_fix_crc b/target/linux/bmips/bcm6328/base-files/etc/uci-defaults/09_fix_crc index 2056ea017f..e521af36ba 100644 --- a/target/linux/bmips/bcm6328/base-files/etc/uci-defaults/09_fix_crc +++ b/target/linux/bmips/bcm6328/base-files/etc/uci-defaults/09_fix_crc @@ -3,6 +3,7 @@ . /lib/functions.sh case "$(board_name)" in +arcadyan,ar7516 |\ comtrend,ar-5381u |\ comtrend,ar-5387un |\ nucom,r5010unv2) diff --git a/target/linux/bmips/dts/bcm6328-arcadyan-ar7516.dts b/target/linux/bmips/dts/bcm6328-arcadyan-ar7516.dts new file mode 100644 index 0000000000..cc50f57549 --- /dev/null +++ b/target/linux/bmips/dts/bcm6328-arcadyan-ar7516.dts @@ -0,0 +1,186 @@ +// SPDX-License-Identifier: GPL-2.0-or-later + +#include "bcm6328.dtsi" + +/ { + model = "Arcadyan AR7516"; + compatible = "arcadyan,ar7516", "brcm,bcm6328"; + + aliases { + led-failsafe = &led_upgrade_green; + led-upgrade = &led_upgrade_green; + }; + + keys { + compatible = "gpio-keys-polled"; + poll-interval = <100>; + + reset { + label = "reset"; + gpios = <&gpio 23 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + + wps { + label = "wps"; + gpios = <&gpio 24 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + }; + + bcm43227-sprom { + compatible = "brcm,bcma-sprom"; + + pci-bus = <1>; + pci-dev = <0>; + + nvmem-cells = <&macaddr_cfe_6a0>; + nvmem-cell-names = "mac-address"; + mac-address-increment = <1>; + + brcm,sprom = "brcm/bcm43227-sprom.bin"; + }; +}; + +&ehci { + status = "okay"; +}; + +ðernet { + status = "okay"; + + nvmem-cells = <&macaddr_cfe_6a0>; + nvmem-cell-names = "mac-address"; +}; + +&hsspi { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + spi-max-frequency = <16666667>; + spi-tx-bus-width = <2>; + spi-rx-bus-width = <2>; + reg = <0>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + cfe: partition@0 { + label = "cfe"; + reg = <0x000000 0x010000>; + read-only; + }; + + partition@10000 { + compatible = "brcm,bcm963xx-imagetag"; + label = "firmware"; + reg = <0x010000 0x7e0000>; + }; + + partition@7f0000 { + label = "nvram"; + reg = <0x7f0000 0x010000>; + }; + }; + }; +}; + +&leds { + status = "okay"; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_ephy0_act_led &pinctrl_ephy1_act_led + &pinctrl_ephy2_act_led &pinctrl_ephy3_act_led + &pinctrl_leds>; + + led_upgrade_green: led@1 { + reg = <1>; + label = "green:upgrade"; + }; + + led@6 { + reg = <6>; + active-low; + label = "green:wan"; + }; + + led@7 { + reg = <7>; + active-low; + label = "green:wifi"; + }; +}; + +&ohci { + status = "okay"; +}; + +&pcie { + status = "okay"; +}; + +&pinctrl { + pinctrl_leds: leds { + function = "led"; + pins = "gpio1", "gpio6", "gpio7"; + }; +}; + +&switch0 { + ports { + port@0 { + reg = <0>; + label = "lan1"; + + phy-handle = <&phy1>; + phy-mode = "mii"; + }; + + port@1 { + reg = <1>; + label = "lan2"; + + phy-handle = <&phy2>; + phy-mode = "mii"; + }; + + port@2 { + reg = <2>; + label = "lan3"; + + phy-handle = <&phy3>; + phy-mode = "mii"; + }; + + port@3 { + reg = <3>; + label = "wan"; + + phy-handle = <&phy4>; + phy-mode = "mii"; + }; + }; +}; + +&uart0 { + status = "okay"; +}; + +&usbh { + status = "okay"; +}; + +&cfe { + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + + macaddr_cfe_6a0: macaddr@6a0 { + reg = <0x6a0 0x6>; + }; +}; diff --git a/target/linux/bmips/image/bcm6328.mk b/target/linux/bmips/image/bcm6328.mk index 8023ef8fa1..fd0cf16dbb 100644 --- a/target/linux/bmips/image/bcm6328.mk +++ b/target/linux/bmips/image/bcm6328.mk @@ -1,5 +1,18 @@ # SPDX-License-Identifier: GPL-2.0-or-later +define Device/arcadyan_ar7516 + $(Device/bcm63xx-cfe) + DEVICE_VENDOR := Arcadyan + DEVICE_MODEL := AR7516 + CHIP_ID := 6328 + CFE_BOARD_ID := AR7516AAW + FLASH_MB := 8 + DEVICE_PACKAGES += $(USB2_PACKAGES) \ + $(B43_PACKAGES) broadcom-43227-sprom \ + kmod-leds-bcm6328 +endef +TARGET_DEVICES += arcadyan_ar7516 + define Device/comtrend_ar-5381u $(Device/bcm63xx-cfe) DEVICE_VENDOR := Comtrend