From: Jonas Gorski Date: Sun, 31 Jul 2016 12:54:52 +0000 (+0200) Subject: uci_network: remove /proc/switch references X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=d0a8c45afe203ad964db29c54496708decf8309c;p=web.git uci_network: remove /proc/switch references Old kmod-switch support was removed a while ago, so remove documentation for it as well. Signed-off-by: Jonas Gorski --- diff --git a/docs/uci_net.txt b/docs/uci_net.txt index d38cbd7..a1d5637 100644 --- a/docs/uci_net.txt +++ b/docs/uci_net.txt @@ -29,28 +29,6 @@ The 'globals' section contains interface-independent options affecting the netwo The 'switch' section is responsible for partitioning the switch into several _VLANs_ which appear as independent interfaces in the system although they share the same hardware. **Not every OpenWrt supported device (or architecture, like x86) has a programmable switch**, therefore this section might not be present on some platforms. Please also note, that some switches only support 4Bit-VLANs. -There are currently two different configuration formats in use, one for the legacy '/proc/switch/' API and one for the newer swconfig-based switch configuration. - -=== /proc/switch === - -This variant is actually only found on Broadcom devices like the WRT54GL. - -A typical configuration for it looks like this: - ----- -config 'switch' 'eth0' - option 'vlan0' '0 1 2 3 5*' - option 'vlan1' '4 5' ----- - -The 'eth0' identifier specifies the switch the section is belonging to. -VLANs are defined by 'vlan#' options with '#' being the VLAN number. - -=== swconfig === - -The newer swconfig framework is intended to replace the legacy switch configuration. - -Configuration for swconfig have a slightly different structure with one extra section per VLAN. The example below shows a typical configuration: ----