From: Florian Fainelli Date: Thu, 28 Aug 2014 22:11:03 +0000 (-0700) Subject: net: systemport: tell RXCHK if we are using Broadcom tags X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=d09d3038a336cbab6bde616ce44266c36c214f81;p=openwrt%2Fstaging%2Fblogic.git net: systemport: tell RXCHK if we are using Broadcom tags When Broadcom tags are enabled, e.g: when interfaced to an Ethernet switch, make sure that we tell the RXCHK engine that it should be expecting a 4-bytes Broadcom tag after the Ethernet MAC Source Address. Use netdev_uses_dsa() to check for that condition since that will tell us if a switch is attached to our network interface. Fixes: 80105befdb4b ("net: systemport: add Broadcom SYSTEMPORT Ethernet MAC driver") Signed-off-by: Florian Fainelli Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/broadcom/bcmsysport.c b/drivers/net/ethernet/broadcom/bcmsysport.c index 6f4e18644bd4..8f91de169663 100644 --- a/drivers/net/ethernet/broadcom/bcmsysport.c +++ b/drivers/net/ethernet/broadcom/bcmsysport.c @@ -139,6 +139,15 @@ static int bcm_sysport_set_rx_csum(struct net_device *dev, else reg &= ~RXCHK_SKIP_FCS; + /* If Broadcom tags are enabled (e.g: using a switch), make + * sure we tell the RXCHK hardware to expect a 4-bytes Broadcom + * tag after the Ethernet MAC Source Address. + */ + if (netdev_uses_dsa(dev)) + reg |= RXCHK_BRCM_TAG_EN; + else + reg &= ~RXCHK_BRCM_TAG_EN; + rxchk_writel(priv, reg, RXCHK_CONTROL); return 0;