From: Álvaro Fernández Rojas Date: Sun, 11 Jun 2023 10:30:57 +0000 (+0200) Subject: bmips: add support for Comtrend WAP-5813n X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=c3b1ef2dfde7201230e3ab69bc41c4b357071bcb;p=openwrt%2Fstaging%2Fthess.git bmips: add support for Comtrend WAP-5813n The Comtrend WAP-5813n is a wifi gigabit router, 2.4 GHz single band with two external antennas. Hardware: - SoC: Broadcom BCM6369 - CPU: dual core BMIPS4350 @ 400Mhz - RAM: 64 MB DDR - Flash: 8 MB parallel NOR - LAN switch: Broadcom BCM53115, 5x 1Gbit - Wifi 2.4 GHz: miniPCI Broadcom BCM4322 802.11bgn - USB: 1x 2.0 (optional) - Buttons: 3x (reset) - LEDs: yes - UART: yes Installation via CFE web UI: 1. Power off the router. 2. Press reset button near the power switch. 3. Keep it pressed while powering up during ~20+ seconds. 4. Browse to http://192.168.1.1 and upload the firmware. 5. Wait a few minutes for it to finish. Signed-off-by: Álvaro Fernández Rojas --- diff --git a/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds b/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds index fb7cca17e5..c7e61fe72f 100644 --- a/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds +++ b/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds @@ -6,6 +6,9 @@ board_config_update case "$(board_name)" in +comtrend,wap-5813n) + ucidef_set_led_usbport "usb" "USB" "green:usb" "usb1-port1" "usb2-port1" + ;; netgear,dgnd3700-v1 |\ netgear,dgnd3800b) ucidef_set_led_netdev "lan" "LAN" "green:lan" "switch.1" diff --git a/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network b/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network index 1b47e5a76f..58fba05fec 100644 --- a/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network +++ b/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network @@ -14,6 +14,7 @@ comtrend,vr-3025un) ucidef_set_bridge_device switch ucidef_set_interface_lan "lan1 lan2 lan3 iptv" ;; +comtrend,wap-5813n |\ netgear,dgnd3700-v1 |\ netgear,dgnd3800b |\ netgear,evg2000) diff --git a/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc b/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc index 7299317947..63d10c9a8e 100644 --- a/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc +++ b/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc @@ -5,6 +5,7 @@ case "$(board_name)" in comtrend,vr-3025u |\ comtrend,vr-3025un |\ +comtrend,wap-5813n |\ netgear,evg2000 |\ observa,vh4032n) mtd fixtrx firmware diff --git a/target/linux/bmips/dts/bcm6369-comtrend-wap-5813n.dts b/target/linux/bmips/dts/bcm6369-comtrend-wap-5813n.dts new file mode 100644 index 0000000000..517a894cf5 --- /dev/null +++ b/target/linux/bmips/dts/bcm6369-comtrend-wap-5813n.dts @@ -0,0 +1,230 @@ +// SPDX-License-Identifier: GPL-2.0-or-later + +#include "bcm6368.dtsi" + +/ { + model = "Comtrend WAP-5813n"; + compatible = "comtrend,wap-5813n", "brcm,bcm6369", "brcm,bcm6368"; + + aliases { + led-boot = &led_power_green; + led-failsafe = &led_power_red; + led-running = &led_power_green; + led-upgrade = &led_power_green; + }; + + keys { + compatible = "gpio-keys-polled"; + poll-interval = <100>; + + wlan { + label = "wlan"; + gpios = <&gpio 32 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + + reset { + label = "reset"; + gpios = <&gpio 34 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + + wps { + label = "wps"; + gpios = <&gpio 35 GPIO_ACTIVE_LOW>; + linux,code = ; + debounce-interval = <60>; + }; + }; + + leds { + compatible = "gpio-leds"; + + led@5 { + label = "green:internet"; + gpios = <&gpio 5 GPIO_ACTIVE_HIGH>; + }; + + led@14 { + label = "green:usb"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + led_power_green: led@22 { + label = "green:power"; + gpios = <&gpio 22 GPIO_ACTIVE_HIGH>; + }; + + led@23 { + label = "green:wps"; + gpios = <&gpio 23 GPIO_ACTIVE_LOW>; + }; + + led_power_red: led@24 { + label = "red:power"; + gpios = <&gpio 24 GPIO_ACTIVE_HIGH>; + panic-indicator; + }; + + led@31 { + label = "red:internet"; + gpios = <&gpio 31 GPIO_ACTIVE_HIGH>; + }; + }; + + bcm4322-sprom { + compatible = "brcm,ssb-sprom"; + + pci-bus = <0>; + pci-dev = <1>; + + nvmem-cells = <&macaddr_cfe_6a0>; + nvmem-cell-names = "mac-address"; + mac-address-increment = <1>; + + brcm,sprom = "brcm/bcm4322-sprom.bin"; + brcm,sprom-fixups = <97 0xfeed>, + <98 0x15d1>, + <99 0xfb0d>, + <113 0xfef7>, + <114 0x15f7>, + <115 0xfb1a>; + }; +}; + +&ehci { + status = "okay"; +}; + +ðernet { + status = "okay"; + + nvmem-cells = <&macaddr_cfe_6a0>; + nvmem-cell-names = "mac-address"; +}; + +&lsspi { + status = "okay"; + + switch@0 { + compatible = "brcm,bcm53115"; + reg = <0>; + spi-max-frequency = <781000>; + dsa,member = <1 0>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + label = "lan4"; + }; + + port@1 { + reg = <1>; + label = "lan3"; + }; + + port@2 { + reg = <2>; + label = "lan2"; + }; + + port@3 { + reg = <3>; + label = "lan1"; + }; + + port@4 { + reg = <4>; + label = "wan"; + }; + + port@5 { + reg = <5>; + + phy-mode = "rgmii"; + ethernet = <&switch0port4>; + + fixed-link { + speed = <1000>; + full-duplex; + }; + }; + }; + }; +}; + +&pflash { + status = "okay"; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + cfe: partition@0 { + label = "CFE"; + reg = <0x000000 0x010000>; + read-only; + }; + + partition@20000 { + label = "firmware"; + reg = <0x010000 0x7e0000>; + compatible = "brcm,bcm963xx-imagetag"; + }; + + partition@fe0000 { + label = "nvram"; + reg = <0x7f0000 0x010000>; + }; + }; +}; + +&ohci { + status = "okay"; +}; + +&pci { + status = "okay"; +}; + +&switch0 { + dsa,member = <0 0>; + + ports { + switch0port4: port@4 { + reg = <4>; + label = "extsw"; + + phy-mode = "rgmii"; + + fixed-link { + speed = <1000>; + full-duplex; + }; + }; + }; +}; + +&uart0 { + status = "okay"; +}; + +&usbh { + status = "okay"; +}; + +&cfe { + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + + macaddr_cfe_6a0: macaddr@6a0 { + reg = <0x6a0 0x6>; + }; +}; diff --git a/target/linux/bmips/image/bcm6368.mk b/target/linux/bmips/image/bcm6368.mk index 67f8bbb09f..83cd096959 100644 --- a/target/linux/bmips/image/bcm6368.mk +++ b/target/linux/bmips/image/bcm6368.mk @@ -27,6 +27,20 @@ define Device/comtrend_vr-3025un endef TARGET_DEVICES += comtrend_vr-3025un +define Device/comtrend_wap-5813n + $(Device/bcm63xx-cfe) + DEVICE_VENDOR := Comtrend + DEVICE_MODEL := WAP-5813n + CHIP_ID := 6368 + SOC := bcm6369 + CFE_BOARD_ID := 96369R-1231N + FLASH_MB := 8 + DEVICE_PACKAGES += $(USB2_PACKAGES) \ + $(B43_PACKAGES) broadcom-4322-sprom \ + kmod-leds-gpio +endef +TARGET_DEVICES += comtrend_wap-5813n + define Device/netgear_dgnd3700-v1 $(Device/bcm63xx-netgear) DEVICE_VENDOR := NETGEAR