From: Michael Weiser Date: Mon, 14 Nov 2016 17:58:07 +0000 (+0100) Subject: net: ethernet: sun4i-emac: Read rxhdr in CPU byte-order X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=934d0048d07d14916b5c6f48709470d96f98d9c3;p=openwrt%2Fstaging%2Fblogic.git net: ethernet: sun4i-emac: Read rxhdr in CPU byte-order The EMAC EMAC_RX_IO_DATA_REG data register is dual-purpose: On one hand it is used to move actual packet data off the wire. This will be in wire-format and accepted as such by higher layers such as IP. Therefore it is correctly read as-is (i.e. raw) using readsl. On the other hand it provides metadata about incoming transfers to the driver such as length and checksum validation status. This data is little-endian, always and it is interpreted by the driver. Therefore it needs to be swapped to CPU endianness to make sense to the driver. This is already done for the "receive header" but not rxhdr. Read rxhdr using readl in order for sun4i-emac to work correctly when running a big-endian kernel. Signed-off-by: Michael Weiser Cc: Maxime Ripard Cc: netdev@vger.kernel.org Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/allwinner/sun4i-emac.c b/drivers/net/ethernet/allwinner/sun4i-emac.c index 74012196bce9..c8f4d26fc9d4 100644 --- a/drivers/net/ethernet/allwinner/sun4i-emac.c +++ b/drivers/net/ethernet/allwinner/sun4i-emac.c @@ -592,8 +592,7 @@ static void emac_rx(struct net_device *dev) /* A packet ready now & Get status/length */ good_packet = true; - emac_inblk_32bit(db->membase + EMAC_RX_IO_DATA_REG, - &rxhdr, sizeof(rxhdr)); + rxhdr = readl(db->membase + EMAC_RX_IO_DATA_REG); if (netif_msg_rx_status(db)) dev_dbg(db->dev, "rxhdr: %x\n", *((int *)(&rxhdr)));