From: Noralf Trønnes Date: Mon, 3 Oct 2016 20:06:11 +0000 (+0200) Subject: i2c: bcm2835: Can't support I2C_M_IGNORE_NAK X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=8d2cc5cc6ee5c0fc48a96bb29af55fc700f66fdf;p=openwrt%2Fstaging%2Fblogic.git i2c: bcm2835: Can't support I2C_M_IGNORE_NAK The controller can't support this flag, so remove it. Documentation/i2c/i2c-protocol states that all of the message is sent: I2C_M_IGNORE_NAK: Normally message is interrupted immediately if there is [NA] from the client. Setting this flag treats any [NA] as [A], and all of message is sent. >From the BCM2835 ARM Peripherals datasheet: The ERR field is set when the slave fails to acknowledge either its address or a data byte written to it. So when the controller doesn't receive an ack, it sets ERR and raises an interrupt. In other words, the whole message is not sent. Signed-off-by: Noralf Trønnes Reviewed-by: Eric Anholt Signed-off-by: Wolfram Sang --- diff --git a/drivers/i2c/busses/i2c-bcm2835.c b/drivers/i2c/busses/i2c-bcm2835.c index 54d510abd46a..565ef69ce614 100644 --- a/drivers/i2c/busses/i2c-bcm2835.c +++ b/drivers/i2c/busses/i2c-bcm2835.c @@ -212,10 +212,6 @@ static int bcm2835_i2c_xfer_msg(struct bcm2835_i2c_dev *i2c_dev, if (likely(!i2c_dev->msg_err)) return 0; - if ((i2c_dev->msg_err & BCM2835_I2C_S_ERR) && - (msg->flags & I2C_M_IGNORE_NAK)) - return 0; - dev_dbg(i2c_dev->dev, "i2c transfer failed: %x\n", i2c_dev->msg_err); if (i2c_dev->msg_err & BCM2835_I2C_S_ERR)