From: Siva Durga Prasad Paladugu <siva.durga.paladugu@xilinx.com>
Date: Sun, 21 Feb 2016 10:16:15 +0000 (+0530)
Subject: net: xilinx_axi: Clear Isolate bit if found during phy setup
X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=8964f241790181b08eae02b2da56fbadb0375930;p=project%2Fbcm63xx%2Fu-boot.git

net: xilinx_axi: Clear Isolate bit if found during phy setup

In SGMII cases the isolate bit might set after DMA and
ethernet resets and hence check and clear during
setup_phy if it was set.

Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
index 46b8d2d07e..3d69bed309 100644
--- a/drivers/net/xilinx_axi_emac.c
+++ b/drivers/net/xilinx_axi_emac.c
@@ -264,11 +264,29 @@ static int axiemac_phy_init(struct udevice *dev)
 /* Setting axi emac and phy to proper setting */
 static int setup_phy(struct udevice *dev)
 {
-	u32 speed, emmc_reg;
+	u16 temp;
+	u32 speed, emmc_reg, ret;
 	struct axidma_priv *priv = dev_get_priv(dev);
 	struct axi_regs *regs = priv->iobase;
 	struct phy_device *phydev = priv->phydev;
 
+	if (priv->interface == PHY_INTERFACE_MODE_SGMII) {
+		/*
+		 * In SGMII cases the isolate bit might set
+		 * after DMA and ethernet resets and hence
+		 * check and clear if set.
+		 */
+		ret = phyread(priv, priv->phyaddr, MII_BMCR, &temp);
+		if (ret)
+			return 0;
+		if (temp & BMCR_ISOLATE) {
+			temp &= ~BMCR_ISOLATE;
+			ret = phywrite(priv, priv->phyaddr, MII_BMCR, temp);
+			if (ret)
+				return 0;
+		}
+	}
+
 	if (phy_startup(phydev)) {
 		printf("axiemac: could not initialize PHY %s\n",
 		       phydev->dev->name);