From: Bastian Ruppert Date: Tue, 4 Oct 2011 23:43:34 +0000 (+0000) Subject: Davinci: ea20: add gpios for LCD backlight control X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=8540b1691981bf68cb063367a595c7985afd3c49;p=project%2Fbcm63xx%2Fu-boot.git Davinci: ea20: add gpios for LCD backlight control Signed-off-by: Bastian Ruppert CC: Sandeep Paulraj Signed-off-by: Sandeep Paulraj --- diff --git a/board/davinci/ea20/ea20.c b/board/davinci/ea20/ea20.c index 1a57baf4e2..c28d8df6ef 100644 --- a/board/davinci/ea20/ea20.c +++ b/board/davinci/ea20/ea20.c @@ -95,7 +95,9 @@ const struct pinmux_config nand_pins[] = { const struct pinmux_config gpio_pins[] = { { pinmux(13), 8, 0 }, /* GPIO6[15] RESETOUTn on SOM*/ { pinmux(13), 8, 5 }, /* GPIO6[10] U0_SW0 on EA20-00101_2*/ - { pinmux(13), 8, 3 } /* GPIO6[12] U0_SW1 on EA20-00101_2*/ + { pinmux(13), 8, 3 }, /* GPIO6[12] U0_SW1 on EA20-00101_2*/ + { pinmux(19), 8, 5 }, /* GPIO6[1] DISP_ON */ + { pinmux(14), 8, 1 } /* GPIO6[6] LCD_B_PWR*/ }; const struct pinmux_config halten_pin[] = { @@ -144,6 +146,16 @@ int board_early_init_f(void) &gpio6_base->set_data); writel((readl(&gpio6_base->dir) & ~(1 << 12)), &gpio6_base->dir); + /* Set LCD_B_PWR low to power down LCD Backlight*/ + writel((readl(&gpio6_base->set_data) & ~(1 << 6)), + &gpio6_base->set_data); + writel((readl(&gpio6_base->dir) & ~(1 << 6)), &gpio6_base->dir); + + /* Set DISP_ON low to disable LCD output*/ + writel((readl(&gpio6_base->set_data) & ~(1 << 1)), + &gpio6_base->set_data); + writel((readl(&gpio6_base->dir) & ~(1 << 1)), &gpio6_base->dir); + #ifndef CONFIG_USE_IRQ irq_init(); #endif