From: Pawel Dembicki Date: Thu, 13 Aug 2020 09:15:56 +0000 (+0200) Subject: layerscape: add flashing manual for LS1012FRDM X-Git-Tag: v21.02.0-rc1~1789 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=81ac2a73bc227484888a2a715f8e4e2e8043804e;p=openwrt%2Fstaging%2Fhauke.git layerscape: add flashing manual for LS1012FRDM LS1012FRDM is supported but there's no flashing instruction in README. This patch adds it. While at it, add a missing saveenv for MAC address setup. Signed-off-by: Pawel Dembicki [add comment about saveenv] Signed-off-by: Adrian Schmutzler --- diff --git a/target/linux/layerscape/README b/target/linux/layerscape/README index 951f3e8984..8cbf05bd15 100644 --- a/target/linux/layerscape/README +++ b/target/linux/layerscape/README @@ -71,6 +71,16 @@ from SD card. 3.2 Program firmware.bin to flash --------------------------------- +* LS1012FRDM (QSPI flash) + Board have only one nor flash bank. Those commands will replace stock + bootloader and firmware. Please refer point 4 for MAC recovery. + + => tftp a0000000 -firmware.bin + => sf probe 0:0 + => sf erase 0 +$filesize + => sf write a0000000 0 $filesize + => reset + * LS1012ARDB (QSPI flash) Start up from bank1, and program firmware to bank2 with below commands. Switch to bank2 to start up OpenWrt. @@ -155,6 +165,7 @@ from SD card. => setenv ethaddr 00:04:9F:04:65:4b => setenv eth1addr 00:04:9F:04:65:4c + => saveenv 5. Other references