From: Lech Perczak Date: Fri, 29 May 2020 18:50:05 +0000 (+0200) Subject: ath79: add support for TP-Link TL-WR802N V1 and V2 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=7e513136c63108bf55b38be4d2b65aa00b0d2b26;p=openwrt%2Fstaging%2Fnoltari.git ath79: add support for TP-Link TL-WR802N V1 and V2 Specification: - SoC: Qualcomm Atheros QCA9533 (560 MHz, MIPS 24Kc) - RAM: 32 MiB - Storage: 4 MiB of Flash on board - Wireless: Built into QCA9533 (Honey Bee), PHY modes b/g/n - Ethernet: 1x100M (port0) Installation through OEM Web Interface: - Connect to TL-WR802N by Ethernet or Wi-Fi - Go to web interface: [V1] http://192.168.0.1 [V2] http://192.168.0.254 Default user is "admin" & password is "admin". On V2, there is no DHCP server running by default, so remember to set IP manually. - Go to "System Tools -> Firmware Upgrade" - Browse for firmware: [V1] "*.factory.bin" [V2] "*.factory-us.bin" or "*.factory-eu.bin" for eu model Web interface may complain if filename is too long. In such case, rename .bin to something shorter. - Click upgrade Installation through tftp: Note: T_OUT, T_IN and GND on the board must be connected to USB TTL Serial Configuration 115200 8n1 - Boot the TL-WR802N - When "Autobooting in 1 seconds" appears type "tpl" followed by enter - Connect to the board Ethernet port (IPADDR: 192.168.1.1, ServerIP: 192.168.1.10) - tftpboot 0x80000000 - Record the result of "printenv bootcmd" - Enter "erase +0x3c0000" (e.g erase 0x9f020000 +0x3c0000) - Enter "cp.b 0x80000000 0x3c0000" (e.g cp.b 0x80000000 0x9f020000 0x3c0000) - Enter "bootm " (e.g bootm 0x9f020000) Notes: When porting from ar71xx target to ath79, I found out that on V2, reset button is on GPIO12 and active low, instead of GPIO11 and active high. By cross-flashing V1 firmware to V2, I confirmed the same is true for V1. Also according to manual of V1, this one also has green LED instead of blue - both of those issues were fixed accordingly. The MAC address assignment has been checked with OEM firmware. Installation manual based on ar71xx support by Thomas Roberts Signed-off-by: Lech Perczak [slightly adjust commit message, add MAC address comment] Signed-off-by: Adrian Schmutzler --- diff --git a/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v1.dts b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v1.dts new file mode 100644 index 0000000000..229c5fa7bd --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v1.dts @@ -0,0 +1,9 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "qca9533_tplink_tl-wr802n.dtsi" + +/ { + model = "TP-Link TL-WR802N v1"; + compatible = "tplink,tl-wr802n-v1", "qca,qca9533"; +}; diff --git a/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v2.dts b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v2.dts new file mode 100644 index 0000000000..cbfd275d2b --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n-v2.dts @@ -0,0 +1,9 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "qca9533_tplink_tl-wr802n.dtsi" + +/ { + model = "TP-Link TL-WR802N v2"; + compatible = "tplink,tl-wr802n-v2", "qca,qca9533"; +}; diff --git a/target/linux/ath79/dts/qca9533_tplink_tl-wr802n.dtsi b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n.dtsi new file mode 100644 index 0000000000..f89d020672 --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_tl-wr802n.dtsi @@ -0,0 +1,99 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include +#include + +#include "qca953x.dtsi" + +/ { + chosen { + bootargs = "console=ttyS0,115200n8"; + }; + + aliases { + led-boot = &led_system; + led-failsafe = &led_system; + led-running = &led_system; + led-upgrade = &led_system; + label-mac-device = &wmac; + }; + + leds { + compatible = "gpio-leds"; + + led_system: system { + label = "tp-link:green:system"; + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + }; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "Reset button"; + linux,code = ; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&spi { + status = "okay"; + + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <50000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + uboot: partition@0 { + label = "u-boot"; + reg = <0x000000 0x020000>; + read-only; + }; + + partition@20000 { + label = "firmware"; + reg = <0x020000 0x3d0000>; + compatible = "tplink,firmware"; + }; + + art: partition@3f0000 { + label = "art"; + reg = <0x3f0000 0x010000>; + read-only; + }; + }; + }; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&art 0x1000>; + mtd-mac-address = <&uboot 0x1fc00>; +}; + +ð0 { + status = "okay"; + + phy-handle = <&swphy4>; + + mtd-mac-address = <&uboot 0x1fc00>; + mtd-mac-address-increment = <1>; +}; + +ð1 { + compatible = "syscon", "simple-mfd"; +}; diff --git a/target/linux/ath79/image/tiny-tp-link.mk b/target/linux/ath79/image/tiny-tp-link.mk index a5a76edd05..6e07d290f9 100644 --- a/target/linux/ath79/image/tiny-tp-link.mk +++ b/target/linux/ath79/image/tiny-tp-link.mk @@ -272,6 +272,30 @@ define Device/tplink_tl-wr743nd-v1 endef TARGET_DEVICES += tplink_tl-wr743nd-v1 +define Device/tplink_tl-wr802n-v1 + $(Device/tplink-4mlzma) + SOC := qca9533 + DEVICE_MODEL := TL-WR802N + DEVICE_VARIANT := v1 + TPLINK_HWID := 0x08020001 + SUPPORTED_DEVICES += tl-wr802n-v1 +endef +TARGET_DEVICES += tplink_tl-wr802n-v1 + +define Device/tplink_tl-wr802n-v2 + $(Device/tplink-4mlzma) + SOC := qca9533 + DEVICE_MODEL := TL-WR802N + DEVICE_VARIANT := v2 + TPLINK_HWID := 0x08020002 + TPLINK_HWREV := 2 + SUPPORTED_DEVICES += tl-wr802n-v2 + IMAGES += factory-us.bin factory-eu.bin + IMAGE/factory-us.bin := tplink-v1-image factory -C US + IMAGE/factory-eu.bin := tplink-v1-image factory -C EU +endef +TARGET_DEVICES += tplink_tl-wr802n-v2 + define Device/tplink_tl-wr841-v5 $(Device/tplink-4m) SOC := ar7240 diff --git a/target/linux/ath79/tiny/base-files/etc/board.d/02_network b/target/linux/ath79/tiny/base-files/etc/board.d/02_network index 5e559363b2..bff17bcce8 100755 --- a/target/linux/ath79/tiny/base-files/etc/board.d/02_network +++ b/target/linux/ath79/tiny/base-files/etc/board.d/02_network @@ -43,7 +43,9 @@ ath79_setup_interfaces() tplink,tl-wa901nd-v2|\ tplink,tl-wa901nd-v4|\ tplink,tl-wa901nd-v5|\ - tplink,tl-wr703n) + tplink,tl-wr703n|\ + tplink,tl-wr802n-v1|\ + tplink,tl-wr802n-v2) ucidef_set_interface_lan "eth0" ;; tplink,tl-mr3220-v1|\ diff --git a/target/linux/ath79/tiny/base-files/etc/uci-defaults/04_led_migration b/target/linux/ath79/tiny/base-files/etc/uci-defaults/04_led_migration new file mode 100644 index 0000000000..377135f530 --- /dev/null +++ b/target/linux/ath79/tiny/base-files/etc/uci-defaults/04_led_migration @@ -0,0 +1,18 @@ +. /lib/functions.sh +. /lib/functions/migrations.sh + +board=$(board_name) +boardonly="${board##*,}" + +case "$board" in +tplink,tl-wr802n-v1) + migrate_leds ":blue:=:green:" + ;; +tplink,tl-wr802n-v2) + migrate_leds "^$boardonly:=tp-link:" + ;; +esac + +migrations_apply system + +exit 0