From: Alexandru Gagniuc Date: Sun, 29 May 2022 01:56:31 +0000 (-0500) Subject: realtek: EnGenius EWS2910P: use the mtd3 partition for root overlay X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=7bba7ccde9cb021e24ec83f1332aafd5898e23ef;p=openwrt%2Fstaging%2Fynezz.git realtek: EnGenius EWS2910P: use the mtd3 partition for root overlay The root overlay is mounted on the "rootfs_data" partition. This comes at the end of the firmware image, courtesy of mtdsplit. There is very little space left (About 1MB), which can fill up rapidly. The "firmware" and "firmware2" partitions are part of the bootloader dual firmware logic. They should contain independent, valid uImages. This leaves "jffs2-cfg" (mtd3) and "jffs2-log" (mtd4) as candidates. mtd3 is about 13.7 MB and is used by the vendor firmware to store configuration settings. It is only erased by vendor firmware during a factory reset. By naming this partition "rootfs_data", it becomes the root overlay, providing significantly more room. Even with mtdsplit wanting to create a "rootfs_data" on the firmware partition, mtd3 is used as the overlay. Rename "jffs2-cfg" to "rootfs_data", and profit from the extra space. Signed-off-by: Alexandru Gagniuc --- diff --git a/target/linux/realtek/dts-5.10/rtl8380_engenius_ews2910p.dts b/target/linux/realtek/dts-5.10/rtl8380_engenius_ews2910p.dts index dd57b2bf48..9b5ddb5ed4 100644 --- a/target/linux/realtek/dts-5.10/rtl8380_engenius_ews2910p.dts +++ b/target/linux/realtek/dts-5.10/rtl8380_engenius_ews2910p.dts @@ -144,7 +144,7 @@ reg = <0x90000 0x10000>; }; partition@a0000 { - label = "jffs2-cfg"; + label = "rootfs_data"; reg = <0xa0000 0xd60000>; }; partition@e00000 {