From: Mauro Carvalho Chehab Date: Wed, 10 Apr 2013 10:33:23 +0000 (-0300) Subject: [media] r820t: use the second table for 7MHz X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=6189f80d5d6ae58b7262a0908cabf7858397711f;p=openwrt%2Fstaging%2Fblogic.git [media] r820t: use the second table for 7MHz The Realtek Kernel driver uses the second DVB-T 7MHz table instead of the first one. Use it as well. Signed-off-by: Mauro Carvalho Chehab Tested-by: Antti Palosaari --- diff --git a/drivers/media/tuners/r820t.c b/drivers/media/tuners/r820t.c index 79ab2b74bd52..1880807e3e8d 100644 --- a/drivers/media/tuners/r820t.c +++ b/drivers/media/tuners/r820t.c @@ -915,6 +915,14 @@ static int r820t_set_tv_standard(struct r820t_priv *priv, flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */ polyfil_cur = 0x60; /* r25[6:5]:min */ } else if (bw == 7) { +#if 0 + /* + * There are two 7 MHz tables defined on the original + * driver, but just the second one seems to be visible + * by rtl2832. Keep this one here commented, as it + * might be needed in the future + */ + if_khz = 4070; filt_cal_lo = 60000; filt_gain = 0x10; /* +3db, 6mhz on */ @@ -926,7 +934,8 @@ static int r820t_set_tv_standard(struct r820t_priv *priv, lt_att = 0x00; /* r31[7], lt att enable */ flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */ polyfil_cur = 0x60; /* r25[6:5]:min */ -#if 0 /* 7 MHz type 2 - nor sure why/where this is used - Perhaps Australia? */ +#endif + /* 7 MHz, second table */ if_khz = 4570; filt_cal_lo = 63000; filt_gain = 0x10; /* +3db, 6mhz on */ @@ -938,7 +947,6 @@ static int r820t_set_tv_standard(struct r820t_priv *priv, lt_att = 0x00; /* r31[7], lt att enable */ flt_ext_widest = 0x00; /* r15[7]: flt_ext_wide off */ polyfil_cur = 0x60; /* r25[6:5]:min */ -#endif } else { if_khz = 4570; filt_cal_lo = 68500;