From: Christian Lamparter Date: Sun, 7 Jun 2020 20:57:46 +0000 (+0200) Subject: ath79: wndr3700 series: fix wifi range & throughput X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=61307544d1f1ab81a2eb3a200164456c59308d81;p=openwrt%2Fstaging%2Fblocktrron.git ath79: wndr3700 series: fix wifi range & throughput This patch adds ar71xx's GPIO setup for the 2.4GHz and 5GHz antennae demultiplexer: | 158 /* 2.4 GHz uses the first fixed antenna group (1, 0, 1, 0) */ | 159 ap9x_pci_setup_wmac_gpio(0, (0xf << 6), (0xa << 6)); | 160 | 161 /* 5 GHz uses the second fixed antenna group (0, 1, 1, 0) */ | 162 ap9x_pci_setup_wmac_gpio(1, (0xf << 6), (0x6 << 6)); This should restore the range and throughput of the 2.4GHz radio on all the derived wndr3700 variants and versions with the AR7161 SoC. A special case is the 5GHz radio. The original wndr3700(v1) will benefit from this change. However the wndr3700v2 and later revisions were unaffected by the missing bits, as there is no demultiplexer present in the later designs. This patch uses gpio-hogs within the device-tree for all wndr3700/wndr3800/wndrmac variants. Notes: Based on the PCB pictures, the WNDR3700(v1) really had eight independent antennae. Four antennae for each radio and all of those were printed on the circut board. The WNDR3700v2 and later have just six antennae. Four of those are printed on the circuit board and serve the 2.4GHz radio. Whereas the remaining two are special 5GHz Rayspan Patch Antennae which are directly connected to the 5GHz radio. Hannu Nyman dug pretty deep and unearthed a treasure of information regarding the history of how these values came to be in the OpenWrt archives: . Mark Mentovai came across the fixed antenna group when he was looking into the driver: fixed_antenna_group 1, (0, 1, 0, 1) fixed_antenna_group 2, (0, 1, 1, 0) fixed_antenna_group 3, (1, 0, 0, 1) fixed_antenna_group 4, (1, 0, 1, 0) Fixes: FS#3088 Reported-by: Luca Bensi Reported-by: Maciej Mazur Reported-by: Hannu Nyman Debugged-by: Hannu Nyman Signed-off-by: Christian Lamparter --- diff --git a/target/linux/ath79/dts/ar7161_netgear_wndr3700.dts b/target/linux/ath79/dts/ar7161_netgear_wndr3700.dts index 75c68d83c7..38a1140968 100644 --- a/target/linux/ath79/dts/ar7161_netgear_wndr3700.dts +++ b/target/linux/ath79/dts/ar7161_netgear_wndr3700.dts @@ -32,3 +32,24 @@ read-only; }; }; + +&ath9k1 { + /* The original WNDR3700(v1) variant have four antennae dedicated + * to the 5GHz radio as well. Again, two antennae are available for + * each chain to switch between. The following configuration is the + * default setting which taken from the vendor's wifi + * code for that radio. + * + * All possible options [GPIO6,GPIO7,GPIO8,GPIO9]: + * [0,1,0,1], [0,1,1,0], [1,0,0,1], [1,0,1,0] + */ + antenna-demux { + gpio-hog; + line-name = "fixed antenna group 2"; + gpios = <6 GPIO_ACTIVE_LOW>, + <7 GPIO_ACTIVE_HIGH>, + <8 GPIO_ACTIVE_HIGH>, + <9 GPIO_ACTIVE_LOW>; + output-high; + }; +}; diff --git a/target/linux/ath79/dts/ar7161_netgear_wndr3700.dtsi b/target/linux/ath79/dts/ar7161_netgear_wndr3700.dtsi index ab4f37da11..f1db1ffd58 100644 --- a/target/linux/ath79/dts/ar7161_netgear_wndr3700.dtsi +++ b/target/linux/ath79/dts/ar7161_netgear_wndr3700.dtsi @@ -160,6 +160,25 @@ qca,no-eeprom; #gpio-cells = <2>; gpio-controller; + + /* all WNDR3700 variants have four antennae dedicated + * to the 2.4GHz radio. Two antennae are available for + * each chain. The following configuration is the + * default setting which taken from the vendor's wifi + * code for that radio. + * + * All possible options [GPIO6,GPIO7,GPIO8,GPIO9]: + * [0,1,0,1], [0,1,1,0], [1,0,0,1], [1,0,1,0] + */ + antenna-demux { + gpio-hog; + line-name = "fixed antenna group 1"; + gpios = <6 GPIO_ACTIVE_LOW>, + <7 GPIO_ACTIVE_HIGH>, + <8 GPIO_ACTIVE_LOW>, + <9 GPIO_ACTIVE_HIGH>; + output-high; + }; }; ath9k1: wifi@0,12 {