From: Felix Fietkau <nbd@openwrt.org>
Date: Sun, 7 Sep 2014 09:45:32 +0000 (+0000)
Subject: ath79: dev-eth: Don't advertise 1gbit in link code word on ar9331
X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=60b81acd602496d9b929d680c78b387d06b80ed1;p=openwrt%2Fstaging%2Fldir.git

ath79: dev-eth: Don't advertise 1gbit in link code word on ar9331

While the AR9331 has a gigabit MAC towards the internal switch, the
integrated PHYs however are only 100-base-tx capable.  The existing code
however advertieses gigabit capability in the link status word.  If you
attach such a PHY to a gigabit capable switch on the remote end, with
some probability it attempts to negotiate gigabit and fails, falling
baco to the AR9331 assuming a 10mbit half-duplex link.  This has been
observed quite frequently with the Carambola2 and gigabit capable
switches.

In ath79_register_eth(), "pdata->has_gbit = 1;" is set unconditionally
for both AR9331 ethernet ports. This is most likely wrong. Despite the
two MAC IP cores being gigabit MACs, the MAC for eth1 is connected to a
100base-T PHY via MII. The has_gbit attribute is used in the ethernet
driver to determine the supported link modes.

So either pdata->has_gbit is not set to 1 anymore, or the ethernet
driver needs to be modified to determine the advertised link code word
on another criteria than pdata->has_gbit.  This patch implements the
former solution.

Signed-off-by: Harald Welte <laforge@gnumonks.org>

SVN-Revision: 42432
---

diff --git a/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c b/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c
index 227f16e4c2..f106e22731 100644
--- a/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c
+++ b/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c
@@ -940,13 +940,13 @@ void __init ath79_register_eth(unsigned int id)
 			pdata->set_speed = ath79_set_speed_dummy;
 
 			pdata->speed = SPEED_1000;
+			pdata->has_gbit = 1;
 			pdata->duplex = DUPLEX_FULL;
 			pdata->switch_data = &ath79_switch_data;
 
 			ath79_switch_data.phy_poll_mask |= BIT(4);
 		}
 
-		pdata->has_gbit = 1;
 		pdata->is_ar724x = 1;
 
 		if (!pdata->fifo_cfg1)