From: Mario Schroen Date: Sun, 31 Mar 2019 19:07:03 +0000 (+0200) Subject: ath79: Add support for TP-Link CPE210 v3 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=5ec205d7ac00de89510a6e71055d45aa57b705e1;p=openwrt%2Fstaging%2Fzorun.git ath79: Add support for TP-Link CPE210 v3 Specifications: * SoC: Qualcomm Atheros QCA9533 (650MHz) * RAM: 64MB * Storage: 8 MB SPI NOR * Wireless: 2.4GHz N based built into SoC 2x2 * Ethernet: 1x 100/10 Mbps, integrated into SoC, 24V POE IN Installation: Flash factory image through stock firmware WEB UI or TFTP To get to TFTP recovery just hold reset button while powering on for around 4-5 seconds and release. Rename factory image to recovery.bin Stock TFTP server IP:192.168.0.100 Stock device TFTP adress:192.168.0.254 Thanks to robimarko for the work inside the ar71xx tree. Thanks to adrianschmutzler for deep discussion and fixes. Signed-off-by: Mario Schroen [Split into DTS/DTSI, read-only config partition in DTSI] Signed-off-by: Adrian Schmutzler [renamed dtsi filename, light subject touches] Signed-off-by: Petr Štetiar --- diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index 68cff4b4b0..47fac18281 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -123,6 +123,14 @@ tplink,archer-c6-v2) ucidef_set_led_switch "lan" "LAN" "tp-link:green:lan" "switch0" "0x3C" ucidef_set_led_switch "wan" "WAN" "tp-link:green:wan" "switch0" "0x02" ;; +tplink,cpe210-v3) + ucidef_set_led_netdev "lan" "LAN" "tp-link:green:lan" "eth0" + ucidef_set_rssimon "wlan0" "200000" "1" + ucidef_set_led_rssi "rssilow" "RSSILOW" "tp-link:green:link1" "wlan0" "1" "100" + ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW" "tp-link:green:link2" "wlan0" "30" "100" + ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "tp-link:green:link3" "wlan0" "60" "100" + ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "tp-link:green:link4" "wlan0" "80" "100" + ;; tplink,re450-v2) ucidef_set_led_netdev "lan_data" "LAN Data" "tp-link:green:lan_data" "eth0" "tx rx" ucidef_set_led_netdev "lan_link" "LAN Link" "tp-link:green:lan_link" "eth0" "link" diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index a328ef36e9..1041af561e 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -19,6 +19,7 @@ ath79_setup_interfaces() pcs,cap324|\ pisen,wmm003n|\ pqi,air-pen|\ + tplink,cpe210-v3|\ tplink,re350k-v1|\ tplink,re450-v2|\ tplink,tl-mr10u|\ diff --git a/target/linux/ath79/dts/qca9533_tplink_cpe210-v3.dts b/target/linux/ath79/dts/qca9533_tplink_cpe210-v3.dts new file mode 100644 index 0000000000..cf1f728d0f --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_cpe210-v3.dts @@ -0,0 +1,9 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "qca9533_tplink_cpe210.dtsi" + +/ { + compatible = "tplink,cpe210-v3", "qca,qca9533"; + model = "TP-LINK CPE210 v3"; +}; diff --git a/target/linux/ath79/dts/qca9533_tplink_cpe210.dtsi b/target/linux/ath79/dts/qca9533_tplink_cpe210.dtsi new file mode 100644 index 0000000000..ee1f904491 --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_cpe210.dtsi @@ -0,0 +1,125 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca953x.dtsi" + +/ { + chosen { + bootargs = "console=ttyS0,115200n8"; + }; + + aliases { + led-boot = &system; + led-failsafe = &system; + led-running = &system; + led-upgrade = &system; + }; + + leds { + compatible = "gpio-leds"; + + lan { + label = "tp-link:green:lan"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + link1 { + label = "tp-link:green:link1"; + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + }; + + link2 { + label = "tp-link:green:link2"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + link3 { + label = "tp-link:green:link3"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + + system: link4 { + label = "tp-link:green:link4"; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + }; + }; + +}; + +&uart { + status = "okay"; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + #address-cells = <1>; + #size-cells = <1>; + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + uboot: partition@0 { + label = "u-boot"; + reg = <0x000000 0x020000>; + read-only; + }; + + partition@20000 { + label = "partition-table"; + reg = <0x020000 0x10000>; + read-only; + }; + + info: partition@30000 { + label = "product-info"; + reg = <0x030000 0x10000>; + read-only; + }; + + partition@40000 { + label = "firmware"; + reg = <0x040000 0x780000>; + compatible = "tplink,firmware"; + }; + + config: partition@7c0000 { + label = "config"; + reg = <0x7c0000 0x30000>; + read-only; + }; + + ART: partition@7f0000 { + label = "ART"; + reg = <0x7f0000 0x10000>; + read-only; + }; + }; + }; +}; + +ð0 { + status = "okay"; + phy-handle = <&swphy4>; + mtd-mac-address = <&info 0x8>; +}; + +ð1 { + compatible = "syscon", "simple-mfd"; +}; + +&wmac { + status = "okay"; + mtd-cal-data = <&ART 0x1000>; + mtd-mac-address = <&info 0x8>; +}; diff --git a/target/linux/ath79/image/generic-tp-link.mk b/target/linux/ath79/image/generic-tp-link.mk index 19a156be79..92d811f10b 100644 --- a/target/linux/ath79/image/generic-tp-link.mk +++ b/target/linux/ath79/image/generic-tp-link.mk @@ -109,6 +109,19 @@ define Device/tplink_archer-c7-v5 endef TARGET_DEVICES += tplink_archer-c7-v5 +define Device/tplink_cpe210-v3 + $(Device/tplink-safeloader) + ATH_SOC := qca9533 + IMAGE_SIZE := 7680k + DEVICE_TITLE := TP-Link CPE210 v3 + DEVICE_PACKAGES := rssileds + TPLINK_BOARD_ID := CPE210V3 + LOADER_TYPE := elf + KERNEL := kernel-bin | append-dtb | lzma | tplink-v1-header -O + SUPPORTED_DEVICES += cpe210-v3 +endef +TARGET_DEVICES += tplink_cpe210-v3 + define Device/tplink_re350k-v1 $(Device/tplink) ATH_SOC := qca9558 diff --git a/tools/firmware-utils/src/tplink-safeloader.c b/tools/firmware-utils/src/tplink-safeloader.c index 50bbd7edc1..f6e70e29db 100644 --- a/tools/firmware-utils/src/tplink-safeloader.c +++ b/tools/firmware-utils/src/tplink-safeloader.c @@ -196,6 +196,41 @@ static struct device_info boards[] = { .last_sysupgrade_partition = "support-list", }, + /** Firmware layout for the CPE210 V3 */ + { + .id = "CPE210V3", + .vendor = "CPE210(TP-LINK|UN|N300-2|00000000):3.0\r\n", + .support_list = + "SupportList:\r\n" + "CPE210(TP-LINK|EU|N300-2|45550000):3.0\r\n" + "CPE210(TP-LINK|UN|N300-2|00000000):3.0\r\n" + "CPE210(TP-LINK|UN|N300-2):3.0\r\n" + "CPE210(TP-LINK|EU|N300-2):3.0\r\n", + .support_trail = '\xff', + .soft_ver = NULL, + + .partitions = { + {"fs-uboot", 0x00000, 0x20000}, + {"partition-table", 0x20000, 0x01000}, + {"default-mac", 0x30000, 0x00020}, + {"product-info", 0x31100, 0x00100}, + {"device-info", 0x31400, 0x00400}, + {"signature", 0x32000, 0x00400}, + {"device-id", 0x33000, 0x00100}, + {"firmware", 0x40000, 0x770000}, + {"soft-version", 0x7b0000, 0x00100}, + {"support-list", 0x7b1000, 0x01000}, + {"user-config", 0x7c0000, 0x10000}, + {"default-config", 0x7d0000, 0x10000}, + {"log", 0x7e0000, 0x10000}, + {"radio", 0x7f0000, 0x10000}, + {NULL, 0, 0} + }, + + .first_sysupgrade_partition = "os-image", + .last_sysupgrade_partition = "support-list", + }, + /** Firmware layout for the CPE510/520 */ { .id = "CPE510",