From: Boris Brezillon Date: Fri, 1 Apr 2016 12:54:22 +0000 (+0200) Subject: mtd: nand: atmel: rely on generic DT parsing done in nand_scan_ident() X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=4f3cab9b4457108a8241ec7a66e03fe0b2cb3646;p=openwrt%2Fstaging%2Fblogic.git mtd: nand: atmel: rely on generic DT parsing done in nand_scan_ident() The core now takes care of parsing generic DT properties in nand_scan_ident() when nand_set_flash_node() has been called. Rely on this initialization instead of calling of_get_nand_xxx() manually. Signed-off-by: Boris Brezillon Tested-by: Boris Brezillon Reviewed-by: Nicolas Ferre --- diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c index 0b5da7271440..5e716f2a8739 100644 --- a/drivers/mtd/nand/atmel_nand.c +++ b/drivers/mtd/nand/atmel_nand.c @@ -36,7 +36,6 @@ #include #include #include -#include #include #include #include @@ -434,14 +433,13 @@ err_buf: static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len) { struct nand_chip *chip = mtd_to_nand(mtd); - struct atmel_nand_host *host = nand_get_controller_data(chip); if (use_dma && len > mtd->oobsize) /* only use DMA for bigger than oob size: better performances */ if (atmel_nand_dma_op(mtd, buf, len, 1) == 0) return; - if (host->board.bus_width_16) + if (chip->options & NAND_BUSWIDTH_16) atmel_read_buf16(mtd, buf, len); else atmel_read_buf8(mtd, buf, len); @@ -450,14 +448,13 @@ static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len) static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len) { struct nand_chip *chip = mtd_to_nand(mtd); - struct atmel_nand_host *host = nand_get_controller_data(chip); if (use_dma && len > mtd->oobsize) /* only use DMA for bigger than oob size: better performances */ if (atmel_nand_dma_op(mtd, (void *)buf, len, 0) == 0) return; - if (host->board.bus_width_16) + if (chip->options & NAND_BUSWIDTH_16) atmel_write_buf16(mtd, buf, len); else atmel_write_buf8(mtd, buf, len); @@ -1507,58 +1504,17 @@ static void atmel_nand_hwctl(struct mtd_info *mtd, int mode) ecc_writel(host->ecc, CR, ATMEL_ECC_RST); } -static int atmel_of_init_port(struct atmel_nand_host *host, - struct device_node *np) +static int atmel_of_init_ecc(struct atmel_nand_host *host, + struct device_node *np) { - u32 val; u32 offset[2]; - int ecc_mode; - struct atmel_nand_data *board = &host->board; - enum of_gpio_flags flags = 0; - - host->caps = (struct atmel_nand_caps *) - of_device_get_match_data(host->dev); - - if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) { - if (val >= 32) { - dev_err(host->dev, "invalid addr-offset %u\n", val); - return -EINVAL; - } - board->ale = val; - } - - if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) { - if (val >= 32) { - dev_err(host->dev, "invalid cmd-offset %u\n", val); - return -EINVAL; - } - board->cle = val; - } - - ecc_mode = of_get_nand_ecc_mode(np); - - board->ecc_mode = ecc_mode < 0 ? NAND_ECC_SOFT : ecc_mode; - - board->on_flash_bbt = of_get_nand_on_flash_bbt(np); - - board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma"); - - if (of_get_nand_bus_width(np) == 16) - board->bus_width_16 = 1; - - board->rdy_pin = of_get_gpio_flags(np, 0, &flags); - board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW); - - board->enable_pin = of_get_gpio(np, 1); - board->det_pin = of_get_gpio(np, 2); + u32 val; host->has_pmecc = of_property_read_bool(np, "atmel,has-pmecc"); - /* load the nfc driver if there is */ - of_platform_populate(np, NULL, NULL, host->dev); - - if (!(board->ecc_mode == NAND_ECC_HW) || !host->has_pmecc) - return 0; /* Not using PMECC */ + /* Not using PMECC */ + if (!(host->nand_chip.ecc.mode == NAND_ECC_HW) || !host->has_pmecc) + return 0; /* use PMECC, get correction capability, sector size and lookup * table offset. @@ -1599,16 +1555,64 @@ static int atmel_of_init_port(struct atmel_nand_host *host, /* Will build a lookup table and initialize the offset later */ return 0; } + if (!offset[0] && !offset[1]) { dev_err(host->dev, "Invalid PMECC lookup table offset\n"); return -EINVAL; } + host->pmecc_lookup_table_offset_512 = offset[0]; host->pmecc_lookup_table_offset_1024 = offset[1]; return 0; } +static int atmel_of_init_port(struct atmel_nand_host *host, + struct device_node *np) +{ + u32 val; + struct atmel_nand_data *board = &host->board; + enum of_gpio_flags flags = 0; + + host->caps = (struct atmel_nand_caps *) + of_device_get_match_data(host->dev); + + if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) { + if (val >= 32) { + dev_err(host->dev, "invalid addr-offset %u\n", val); + return -EINVAL; + } + board->ale = val; + } + + if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) { + if (val >= 32) { + dev_err(host->dev, "invalid cmd-offset %u\n", val); + return -EINVAL; + } + board->cle = val; + } + + board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma"); + + board->rdy_pin = of_get_gpio_flags(np, 0, &flags); + board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW); + + board->enable_pin = of_get_gpio(np, 1); + board->det_pin = of_get_gpio(np, 2); + + /* load the nfc driver if there is */ + of_platform_populate(np, NULL, NULL, host->dev); + + /* + * Initialize ECC mode to NAND_ECC_SOFT so that we have a correct value + * even if the nand-ecc-mode property is not defined. + */ + host->nand_chip.ecc.mode = NAND_ECC_SOFT; + + return 0; +} + static int atmel_hw_nand_init_params(struct platform_device *pdev, struct atmel_nand_host *host) { @@ -2150,6 +2154,11 @@ static int atmel_nand_probe(struct platform_device *pdev) } else { memcpy(&host->board, dev_get_platdata(&pdev->dev), sizeof(struct atmel_nand_data)); + nand_chip->ecc.mode = host->board.ecc_mode; + + /* 16-bit bus width */ + if (host->board.bus_width_16) + nand_chip->options |= NAND_BUSWIDTH_16; } /* link the private data structures */ @@ -2191,11 +2200,8 @@ static int atmel_nand_probe(struct platform_device *pdev) nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl; } - nand_chip->ecc.mode = host->board.ecc_mode; nand_chip->chip_delay = 40; /* 40us command delay time */ - if (host->board.bus_width_16) /* 16-bit bus width */ - nand_chip->options |= NAND_BUSWIDTH_16; nand_chip->read_buf = atmel_read_buf; nand_chip->write_buf = atmel_write_buf; @@ -2228,11 +2234,6 @@ static int atmel_nand_probe(struct platform_device *pdev) } } - if (host->board.on_flash_bbt || on_flash_bbt) { - dev_info(&pdev->dev, "Use On Flash BBT\n"); - nand_chip->bbt_options |= NAND_BBT_USE_FLASH; - } - if (!host->board.has_dma) use_dma = 0; @@ -2259,6 +2260,18 @@ static int atmel_nand_probe(struct platform_device *pdev) goto err_scan_ident; } + if (host->board.on_flash_bbt || on_flash_bbt) + nand_chip->bbt_options |= NAND_BBT_USE_FLASH; + + if (nand_chip->bbt_options & NAND_BBT_USE_FLASH) + dev_info(&pdev->dev, "Use On Flash BBT\n"); + + if (IS_ENABLED(CONFIG_OF) && pdev->dev.of_node) { + res = atmel_of_init_ecc(host, pdev->dev.of_node); + if (res) + goto err_hw_ecc; + } + if (nand_chip->ecc.mode == NAND_ECC_HW) { if (host->has_pmecc) res = atmel_pmecc_nand_init_params(pdev, host);