From: Christian Lamparter Date: Thu, 23 Dec 2021 20:45:19 +0000 (+0100) Subject: apm821xx: remove overlapping partitions X-Git-Tag: v22.03.0-rc1~874 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=4e6ebdd7ce691512316978cbf329a82fbfc46a2a;p=openwrt%2Fopenwrt.git apm821xx: remove overlapping partitions Apart from the dtb partition, these were all "read-only;" they serve no purpose other than being a copy of what netgear had defined in their original firmware. Signed-off-by: Christian Lamparter --- diff --git a/target/linux/apm821xx/dts/netgear-wndr4700.dts b/target/linux/apm821xx/dts/netgear-wndr4700.dts index 286eba203b..6ec3d3ee63 100644 --- a/target/linux/apm821xx/dts/netgear-wndr4700.dts +++ b/target/linux/apm821xx/dts/netgear-wndr4700.dts @@ -177,24 +177,13 @@ nand { nand-is-boot-medium; - partition0,0@0 { - label = "NAND 128MiB 3,3V 8-bit"; - reg = <0x00000000 0x08000000>; - read-only; - }; - - partition0,1@0 { + partition@0 { label = "uboot"; reg = <0x00000000 0x00180000>; read-only; }; - partition0,2@180000 { - label = "device-tree"; - reg = <0x00180000 0x00020000>; - }; - - partition0,3@180000 { + partition@180000 { label = "kernel"; reg = <0x00180000 0x00380000>; /* @@ -208,52 +197,54 @@ */ }; - partition0,4@500000 { + partition@500000 { label = "ubi"; reg = <0x00500000 0x014e0000>; }; - partition0,5@19e0000 { + + /* + * Netgear's u-boot in the fw_recovery mode (can be + * triggered by holding the reset button, or if + * "bootm" fails) will not flash past this point + * (= 0x19E0000). + */ + + partition@19e0000 { label = "config"; reg = <0x019e0000 0x00080000>; read-only; }; - partition0,6@1a60000 { + partition@1a60000 { label = "pot"; reg = <0x01a60000 0x00080000>; read-only; }; - partition0,7@1ae0000 { + partition@1ae0000 { label = "traffic_meter"; reg = <0x01ae0000 0x00300000>; read-only; }; - partition0,8@1de0000 { + partition@1de0000 { label = "language"; reg = <0x01de0000 0x001c0000>; read-only; }; - partition0,9@1fa0000 { + partition@1fa0000 { label = "ecos"; reg = <0x01fa0000 0x06020000>; read-only; }; - partition0,10@7fc0000 { + partition@7fc0000 { label = "wifi_data"; reg = <0x07fc0000 0x00040000>; read-only; }; - - partition0,11@180000 { - label = "firmware"; - reg = <0x00180000 0x01860000>; - read-only; - }; }; }; };