From: Paul Fertser Date: Tue, 27 Oct 2020 11:02:53 +0000 (+0300) Subject: ath79: fix ath10k caldata extraction on some D-Link DIR-842 C3 devices X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=4d36569b9cab6422d31bda5501718177f2f9c990;p=openwrt%2Fstaging%2Fneocturne.git ath79: fix ath10k caldata extraction on some D-Link DIR-842 C3 devices According to forum threads [0][1] and a report on IRC by Doc-Saintly some of those boards have calibration data in a different place. Only one alternative location is known. Without proper board calibration data (board.bin having all 0xff bytes) ath10k firmware still tries to load but crashes on startup with a confusing error message. If you're applying this patch manually on your device do not forget to remove /lib/firmware/ath10k/pre-cal-pci-0000:00:00.0.bin and reboot to force caldata re-extraction. [0] https://forum.openwrt.org/t/support-for-d-link-dir842-rev-c3/41654 [1] https://forum.openwrt.org/t/d-link-dir-842-cant-access-firmware-upload-form/65454 Signed-off-by: Paul Fertser --- diff --git a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index e968658cac..a72ed0206b 100644 --- a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -169,13 +169,18 @@ case "$FIRMWARE" in ;; dlink,dir-842-c1|\ dlink,dir-842-c2|\ - dlink,dir-842-c3|\ - nec,wg1200cr) + dlink,dir-842-c3) caldata_extract "art" 0x5000 0x2f20 + caldata_valid "202f" || caldata_extract "reserved" 0x15000 0x2f20 ath10k_patch_mac $(mtd_get_mac_ascii devdata wlan5mac) ln -sf /lib/firmware/ath10k/pre-cal-pci-0000\:00\:00.0.bin \ /lib/firmware/ath10k/QCA9888/hw2.0/board.bin ;; + nec,wg1200cr) + caldata_extract "art" 0x5000 0x2f20 + ath10k_patch_mac $(mtd_get_mac_ascii devdata wlan5mac) + ln -sf /lib/firmware/ath10k/pre-cal-pci-0000\:00\:00.0.bin \ + /lib/firmware/ath10k/QCA9888/hw2.0/board.bin netgear,ex6400|\ netgear,ex7300) caldata_extract "caldata" 0x5000 0x2f20