From: David Bauer Date: Sat, 5 Sep 2020 23:24:00 +0000 (+0200) Subject: ipq40xx: essedma: enable VLAN tag offload for single-port X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=2e6c236abd0bebe82bf9020941f34344acb3ae1f;p=openwrt%2Fstaging%2Fthess.git ipq40xx: essedma: enable VLAN tag offload for single-port Enable the VLAN tag offloading mechanism for RGMII single-port devices. This allows those devices to use 802.1Q VLANs on the ethernet port. Previously, RX frames were double tagged, as the RX TAG removal flag was not enabled and an additional 802.1Q header was inserted elsewhere in the code. On the TX side, tagging was completely not present for single-port devices. Enable tagging if an 802.1Q frame should be transmitted and disable the default tagging mechanism for single-port devices. Tested on Aruba AP-303 Signed-off-by: David Bauer --- diff --git a/target/linux/ipq40xx/files-5.4/drivers/net/ethernet/qualcomm/essedma/edma.c b/target/linux/ipq40xx/files-5.4/drivers/net/ethernet/qualcomm/essedma/edma.c index 5561cc23ea..5f2630ae50 100644 --- a/target/linux/ipq40xx/files-5.4/drivers/net/ethernet/qualcomm/essedma/edma.c +++ b/target/linux/ipq40xx/files-5.4/drivers/net/ethernet/qualcomm/essedma/edma.c @@ -164,10 +164,8 @@ static void edma_configure_rx(struct edma_common_info *edma_cinfo) /* Set Rx FIFO threshold to start to DMA data to host */ rxq_ctrl_data = EDMA_FIFO_THRESH_128_BYTE; - if (!edma_cinfo->is_single_phy) { /* Set RX remove vlan bit */ rxq_ctrl_data |= EDMA_RXQ_CTRL_RMV_VLAN; - } edma_write_reg(EDMA_REG_RXQ_CTRL, rxq_ctrl_data); } @@ -1411,12 +1409,10 @@ netdev_tx_t edma_xmit(struct sk_buff *skb, } /* Check and mark VLAN tag offload */ - if (!adapter->edma_cinfo->is_single_phy) { - if (unlikely(skb_vlan_tag_present(skb))) - flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_FLAG; - else if (adapter->default_vlan_tag) - flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_DEFAULT_FLAG; - } + if (unlikely(skb_vlan_tag_present(skb))) + flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_FLAG; + else if (!adapter->edma_cinfo->is_single_phy && adapter->default_vlan_tag) + flags_transmit |= EDMA_VLAN_TX_TAG_INSERT_DEFAULT_FLAG; /* Check and mark checksum offload */ if (likely(skb->ip_summed == CHECKSUM_PARTIAL))