From: Piotr Dymacz Date: Thu, 17 Feb 2022 22:22:25 +0000 (+0100) Subject: ath79: add support for ALFA Network Tube-2HQ X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=131671bc54dff89c33c10241b8fca8fa34a9b2bf;p=openwrt%2Fstaging%2Frobimarko.git ath79: add support for ALFA Network Tube-2HQ ALFA Network Tube-2HQ is a successor of the Tube-2H/P series (EOL) which was based on the Atheros AR9331. The new version uses Qualcomm QCA9531. Specifications: - Qualcomm/Atheros QCA9531 v2 - 650/400/200 MHz (CPU/DDR/AHB) - 64 or 128 MB of RAM (DDR2) - 16+ MB of flash (SPI NOR) - 1x 10/100 Mbps Ethernet with passive PoE input (24 V) (802.3at/af PoE support with optional module) - 1T1R 2.4 GHz Wi-Fi with external PA (SE2623L, up to 27 dBm) and LNA - 1x Type-N (male) antenna connector - 6x LED (5x driven by GPIO) - 1x button (reset) - external h/w watchdog (EM6324QYSP5B, enabled by default) - UART (4-pin, 2.00 mm pitch) header on PCB Flash instruction: You can use sysupgrade image directly in vendor firmware which is based on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot: 1. Configure PC with static IP 192.168.1.2/24. 2. Connect PC with one of RJ45 ports, press the reset button, power up device, wait for first blink of all LEDs (indicates network setup), then keep button for 3 following blinks and release it. 3. Open 192.168.1.1 address in your browser and upload sysupgrade image. Signed-off-by: Piotr Dymacz --- diff --git a/target/linux/ath79/dts/qca9531_alfa-network_tube-2hq.dts b/target/linux/ath79/dts/qca9531_alfa-network_tube-2hq.dts new file mode 100644 index 0000000000..f81fe287df --- /dev/null +++ b/target/linux/ath79/dts/qca9531_alfa-network_tube-2hq.dts @@ -0,0 +1,65 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "qca9531_alfa-network_r36a.dtsi" + +/ { + model = "ALFA Network Tube-2HQ"; + compatible = "alfa-network,tube-2hq", "qca,qca9531"; + + aliases { + led-boot = &led_signal4; + led-failsafe = &led_signal4; + led-upgrade = &led_signal4; + }; + + leds { + compatible = "gpio-leds"; + + pinctrl-names = "default"; + pinctrl-0 = <&enable_gpio4 &enable_gpio16>; + + lan { + label = "blue:lan"; + gpios = <&gpio 4 GPIO_ACTIVE_LOW>; + }; + + led_signal4: signal4 { + label = "green:signal4"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + signal1 { + label = "red:signal1"; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + }; + + signal2 { + label = "orange:signal2"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + signal3 { + label = "green:signal3"; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + }; + }; +}; + +ð0 { + nvmem-cells = <&macaddr_art_1002>; + nvmem-cell-names = "mac-address"; + + mac-address-increment = <(-1)>; +}; + +ð1 { + compatible = "syscon", "simple-mfd"; +}; + +&usb0 { + status = "disabled"; +}; + +&usb_phy { + status = "disabled"; +}; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index 18904f8528..354df1da6f 100644 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -48,6 +48,14 @@ alfa-network,r36a) ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0" ucidef_set_led_switch "wan" "WAN" "blue:wan" "switch0" "0x10" ;; +alfa-network,tube-2hq) + ucidef_set_led_netdev "lan" "LAN" "blue:lan" "eth0" + ucidef_set_rssimon "wlan0" "200000" "1" + ucidef_set_led_rssi "signal1" "SIGNAL1" "red:signal1" "wlan0" "1" "100" + ucidef_set_led_rssi "signal2" "SIGNAL2" "orange:signal2" "wlan0" "25" "100" + ucidef_set_led_rssi "signal3" "SIGNAL3" "green:signal3" "wlan0" "50" "100" + ucidef_set_led_rssi "signal4" "SIGNAL4" "green:signal4" "wlan0" "75" "100" + ;; asus,rp-ac66) ucidef_set_rssimon "wlan0" "200000" "1" ucidef_set_rssimon "wlan1" "200000" "1" diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 447d1cdea2..bb5c63a33e 100644 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -13,6 +13,7 @@ ath79_setup_interfaces() allnet,all-wap02860ac|\ alfa-network,ap121f|\ alfa-network,pi-wifi4|\ + alfa-network,tube-2hq|\ arduino,yun|\ aruba,ap-105|\ asus,rp-ac66|\ @@ -529,6 +530,7 @@ ath79_setup_macs() alfa-network,n5q|\ alfa-network,pi-wifi4|\ alfa-network,r36a|\ + alfa-network,tube-2hq|\ engenius,eap300-v2|\ engenius,ens202ext-v1) label_mac=$(mtd_get_mac_binary art 0x1002) diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index b01eff7d0b..27a9860d28 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -298,6 +298,16 @@ define Device/alfa-network_r36a endef TARGET_DEVICES += alfa-network_r36a +define Device/alfa-network_tube-2hq + SOC := qca9531 + DEVICE_VENDOR := ALFA Network + DEVICE_MODEL := Tube-2HQ + DEVICE_PACKAGES := rssileds -swconfig + IMAGE_SIZE := 15872k + SUPPORTED_DEVICES += tube-2hq +endef +TARGET_DEVICES += alfa-network_tube-2hq + define Device/allnet_all-wap02860ac $(Device/senao_loader_okli) SOC := qca9558