From: Rafał Miłecki Date: Thu, 12 Oct 2017 08:21:26 +0000 (+0200) Subject: net: bgmac: enable master mode for BCM54210E and B50212E PHYs X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=12acd136913ccdf394eeb2bc8686ff5505368119;p=openwrt%2Fstaging%2Fblogic.git net: bgmac: enable master mode for BCM54210E and B50212E PHYs There are 4 very similar PHYs: 0x600d84a1: BCM54210E (rev B0) 0x600d84a2: BCM54210E (rev B1) 0x600d84a5: B50212E (rev B0) 0x600d84a6: B50212E (rev B1) that need setting master mode manually. It's because they run in slave mode by default with Automatic Slave/Master configuration disabled which can lead to unreliable connection with massive ping loss. So far it was reported for a board with BCM47189 SoC and B50212E B1 PHY connected to the bgmac supported ethernet device. Telling PHY driver to setup PHY properly solves this issue. Signed-off-by: Rafał Miłecki Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/broadcom/bgmac-bcma.c b/drivers/net/ethernet/broadcom/bgmac-bcma.c index 6322594ab260..6fe074c1588b 100644 --- a/drivers/net/ethernet/broadcom/bgmac-bcma.c +++ b/drivers/net/ethernet/broadcom/bgmac-bcma.c @@ -184,13 +184,19 @@ static int bgmac_probe(struct bcma_device *core) if (!bgmac_is_bcm4707_family(core) && !(ci->id == BCMA_CHIP_ID_BCM53573 && core->core_unit == 1)) { + struct phy_device *phydev; + mii_bus = bcma_mdio_mii_register(bgmac); if (IS_ERR(mii_bus)) { err = PTR_ERR(mii_bus); goto err; } - bgmac->mii_bus = mii_bus; + + phydev = mdiobus_get_phy(bgmac->mii_bus, bgmac->phyaddr); + if (ci->id == BCMA_CHIP_ID_BCM53573 && phydev && + (phydev->drv->phy_id & phydev->drv->phy_id_mask) == PHY_ID_BCM54210E) + phydev->dev_flags |= PHY_BRCM_EN_MASTER_MODE; } if (core->bus->hosttype == BCMA_HOSTTYPE_PCI) {