From: Tomasz Maciej Nowak Date: Mon, 24 May 2021 12:41:15 +0000 (+0200) Subject: x86: add Roqos Core RC10 ethernet interfaces X-Git-Tag: mikrotik~1921 X-Git-Url: http://git.lede-project.org./?a=commitdiff_plain;h=09448d8ff30d7c1474c8dd0a762efe0417c471bd;p=openwrt%2Fstaging%2Fchunkeey.git x86: add Roqos Core RC10 ethernet interfaces eth0 -> single NIC (i211at) eth1 -> single NIC (i211at) -> 4-port unmanaged switch (BCM53125U) Notes UART is exposed on J4 connector, pinout starting from pin marked 1: 1. GND, 2. NC?, 3. NC?, 4. RX, 5. TX, 6. NC? baud: 115200, parity: none, flow control: none The board is setup by coreboot with UEFI. To enter setup screen hold ESC key on boot. The 5-LED multicolor matrix is attached on first I2C device named "Synopsys DesignWare I2C adapter" at address 0x60. Controlling values are stored in /opt/roqos/etc/rcLED.conf of original firmware. Remember to backup the original firmware, there are no downloadable copies. Signed-off-by: Tomasz Maciej Nowak --- diff --git a/target/linux/x86/base-files/etc/board.d/02_network b/target/linux/x86/base-files/etc/board.d/02_network index 581daf49b6..30035dcbe9 100644 --- a/target/linux/x86/base-files/etc/board.d/02_network +++ b/target/linux/x86/base-files/etc/board.d/02_network @@ -11,6 +11,9 @@ case "$(board_name)" in pc-engines-apu1|pc-engines-apu2|pc-engines-apu3) ucidef_set_interfaces_lan_wan "eth1 eth2" "eth0" ;; +roqos-roqos-core-rc10) + ucidef_set_interfaces_lan_wan "eth1" "eth0" + ;; sophos-sg-105|sophos-xg-105) ucidef_set_interfaces_lan_wan "eth0 eth2 eth3" "eth1" ;;