#include "aes_ccm.h"
#include "debugfs_key.h"
-static int ieee80211_regdom = 0x10; /* FCC */
-module_param(ieee80211_regdom, int, 0444);
-MODULE_PARM_DESC(ieee80211_regdom, "IEEE 802.11 regulatory domain; 64=MKK");
-
-/*
- * If firmware is upgraded by the vendor, additional channels can be used based
- * on the new Japanese regulatory rules. This is indicated by setting
- * ieee80211_japan_5ghz module parameter to one when loading the 80211 kernel
- * module.
- */
-static int ieee80211_japan_5ghz /* = 0 */;
-module_param(ieee80211_japan_5ghz, int, 0444);
-MODULE_PARM_DESC(ieee80211_japan_5ghz, "Vendor-updated firmware for 5 GHz");
-
static void ieee80211_set_hw_encryption(struct net_device *dev,
struct sta_info *sta, u8 addr[ETH_ALEN],
struct ieee80211_key *key)
}
-struct ieee80211_channel_range {
- short start_freq;
- short end_freq;
- unsigned char power_level;
- unsigned char antenna_max;
-};
-
-static const struct ieee80211_channel_range ieee80211_fcc_channels[] = {
- { 2412, 2462, 27, 6 } /* IEEE 802.11b/g, channels 1..11 */,
- { 5180, 5240, 17, 6 } /* IEEE 802.11a, channels 36..48 */,
- { 5260, 5320, 23, 6 } /* IEEE 802.11a, channels 52..64 */,
- { 5745, 5825, 30, 6 } /* IEEE 802.11a, channels 149..165, outdoor */,
- { 0 }
-};
-
-static const struct ieee80211_channel_range ieee80211_mkk_channels[] = {
- { 2412, 2472, 20, 6 } /* IEEE 802.11b/g, channels 1..13 */,
- { 5170, 5240, 20, 6 } /* IEEE 802.11a, channels 34..48 */,
- { 5260, 5320, 20, 6 } /* IEEE 802.11a, channels 52..64 */,
- { 0 }
-};
-
-
-static const struct ieee80211_channel_range *channel_range =
- ieee80211_fcc_channels;
-
-
-static void ieee80211_unmask_channel(struct net_device *dev, int mode,
- struct ieee80211_channel *chan)
-{
- int i;
-
- chan->flag = 0;
-
- if (ieee80211_regdom == 64 &&
- (mode == MODE_ATHEROS_TURBO || mode == MODE_ATHEROS_TURBOG)) {
- /* Do not allow Turbo modes in Japan. */
- return;
- }
-
- for (i = 0; channel_range[i].start_freq; i++) {
- const struct ieee80211_channel_range *r = &channel_range[i];
- if (r->start_freq <= chan->freq && r->end_freq >= chan->freq) {
- if (ieee80211_regdom == 64 && !ieee80211_japan_5ghz &&
- chan->freq >= 5260 && chan->freq <= 5320) {
- /*
- * Skip new channels in Japan since the
- * firmware was not marked having been upgraded
- * by the vendor.
- */
- continue;
- }
-
- if (ieee80211_regdom == 0x10 &&
- (chan->freq == 5190 || chan->freq == 5210 ||
- chan->freq == 5230)) {
- /* Skip MKK channels when in FCC domain. */
- continue;
- }
-
- chan->flag |= IEEE80211_CHAN_W_SCAN |
- IEEE80211_CHAN_W_ACTIVE_SCAN |
- IEEE80211_CHAN_W_IBSS;
- chan->power_level = r->power_level;
- chan->antenna_max = r->antenna_max;
-
- if (ieee80211_regdom == 64 &&
- (chan->freq == 5170 || chan->freq == 5190 ||
- chan->freq == 5210 || chan->freq == 5230)) {
- /*
- * New regulatory rules in Japan have backwards
- * compatibility with old channels in 5.15-5.25
- * GHz band, but the station is not allowed to
- * use active scan on these old channels.
- */
- chan->flag &= ~IEEE80211_CHAN_W_ACTIVE_SCAN;
- }
-
- if (ieee80211_regdom == 64 &&
- (chan->freq == 5260 || chan->freq == 5280 ||
- chan->freq == 5300 || chan->freq == 5320)) {
- /*
- * IBSS is not allowed on 5.25-5.35 GHz band
- * due to radar detection requirements.
- */
- chan->flag &= ~IEEE80211_CHAN_W_IBSS;
- }
-
- break;
- }
- }
-}
-
-
-static int ieee80211_unmask_channels(struct net_device *dev)
-{
- struct ieee80211_local *local = wdev_priv(dev->ieee80211_ptr);
- struct ieee80211_hw_mode *mode;
- int c;
-
- list_for_each_entry(mode, &local->modes_list, list) {
- for (c = 0; c < mode->num_channels; c++) {
- ieee80211_unmask_channel(dev, mode->mode,
- &mode->channels[c]);
- }
- }
- return 0;
-}
-
-
-int ieee80211_init_client(struct net_device *dev)
-{
- if (ieee80211_regdom == 0x40)
- channel_range = ieee80211_mkk_channels;
- ieee80211_unmask_channels(dev);
- return 0;
-}
-
-
static int ieee80211_ioctl_siwmode(struct net_device *dev,
struct iw_request_info *info,
__u32 *mode, char *extra)
--- /dev/null
+/*
+ * Copyright 2002-2005, Instant802 Networks, Inc.
+ * Copyright 2005-2006, Devicescape Software, Inc.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+/*
+ * This regulatory domain control implementation is known to be incomplete
+ * and confusing. mac80211 regulatory domain control will be significantly
+ * reworked in the not-too-distant future.
+ *
+ * For now, drivers wishing to control which channels are and aren't available
+ * are advised as follows:
+ * - set the IEEE80211_HW_DEFAULT_REG_DOMAIN_CONFIGURED flag
+ * - continue to include *ALL* possible channels in the modes registered
+ * through ieee80211_register_hwmode()
+ * - for each allowable ieee80211_channel structure registered in the above
+ * call, set the flag member to some meaningful value such as
+ * IEEE80211_CHAN_W_SCAN | IEEE80211_CHAN_W_ACTIVE_SCAN |
+ * IEEE80211_CHAN_W_IBSS.
+ * - leave flag as 0 for non-allowable channels
+ *
+ * The usual implementation is for a driver to read a device EEPROM to
+ * determine which regulatory domain it should be operating under, then
+ * looking up the allowable channels in a driver-local table, then performing
+ * the above.
+ */
+
+#include <linux/module.h>
+#include <linux/netdevice.h>
+#include <net/mac80211.h>
+
+static int ieee80211_regdom = 0x10; /* FCC */
+module_param(ieee80211_regdom, int, 0444);
+MODULE_PARM_DESC(ieee80211_regdom, "IEEE 802.11 regulatory domain; 64=MKK");
+
+/*
+ * If firmware is upgraded by the vendor, additional channels can be used based
+ * on the new Japanese regulatory rules. This is indicated by setting
+ * ieee80211_japan_5ghz module parameter to one when loading the 80211 kernel
+ * module.
+ */
+static int ieee80211_japan_5ghz /* = 0 */;
+module_param(ieee80211_japan_5ghz, int, 0444);
+MODULE_PARM_DESC(ieee80211_japan_5ghz, "Vendor-updated firmware for 5 GHz");
+
+
+struct ieee80211_channel_range {
+ short start_freq;
+ short end_freq;
+ unsigned char power_level;
+ unsigned char antenna_max;
+};
+
+static const struct ieee80211_channel_range ieee80211_fcc_channels[] = {
+ { 2412, 2462, 27, 6 } /* IEEE 802.11b/g, channels 1..11 */,
+ { 5180, 5240, 17, 6 } /* IEEE 802.11a, channels 36..48 */,
+ { 5260, 5320, 23, 6 } /* IEEE 802.11a, channels 52..64 */,
+ { 5745, 5825, 30, 6 } /* IEEE 802.11a, channels 149..165, outdoor */,
+ { 0 }
+};
+
+static const struct ieee80211_channel_range ieee80211_mkk_channels[] = {
+ { 2412, 2472, 20, 6 } /* IEEE 802.11b/g, channels 1..13 */,
+ { 5170, 5240, 20, 6 } /* IEEE 802.11a, channels 34..48 */,
+ { 5260, 5320, 20, 6 } /* IEEE 802.11a, channels 52..64 */,
+ { 0 }
+};
+
+
+static const struct ieee80211_channel_range *channel_range =
+ ieee80211_fcc_channels;
+
+
+static void ieee80211_unmask_channel(int mode, struct ieee80211_channel *chan)
+{
+ int i;
+
+ chan->flag = 0;
+
+ if (ieee80211_regdom == 64 &&
+ (mode == MODE_ATHEROS_TURBO || mode == MODE_ATHEROS_TURBOG)) {
+ /* Do not allow Turbo modes in Japan. */
+ return;
+ }
+
+ for (i = 0; channel_range[i].start_freq; i++) {
+ const struct ieee80211_channel_range *r = &channel_range[i];
+ if (r->start_freq <= chan->freq && r->end_freq >= chan->freq) {
+ if (ieee80211_regdom == 64 && !ieee80211_japan_5ghz &&
+ chan->freq >= 5260 && chan->freq <= 5320) {
+ /*
+ * Skip new channels in Japan since the
+ * firmware was not marked having been upgraded
+ * by the vendor.
+ */
+ continue;
+ }
+
+ if (ieee80211_regdom == 0x10 &&
+ (chan->freq == 5190 || chan->freq == 5210 ||
+ chan->freq == 5230)) {
+ /* Skip MKK channels when in FCC domain. */
+ continue;
+ }
+
+ chan->flag |= IEEE80211_CHAN_W_SCAN |
+ IEEE80211_CHAN_W_ACTIVE_SCAN |
+ IEEE80211_CHAN_W_IBSS;
+ chan->power_level = r->power_level;
+ chan->antenna_max = r->antenna_max;
+
+ if (ieee80211_regdom == 64 &&
+ (chan->freq == 5170 || chan->freq == 5190 ||
+ chan->freq == 5210 || chan->freq == 5230)) {
+ /*
+ * New regulatory rules in Japan have backwards
+ * compatibility with old channels in 5.15-5.25
+ * GHz band, but the station is not allowed to
+ * use active scan on these old channels.
+ */
+ chan->flag &= ~IEEE80211_CHAN_W_ACTIVE_SCAN;
+ }
+
+ if (ieee80211_regdom == 64 &&
+ (chan->freq == 5260 || chan->freq == 5280 ||
+ chan->freq == 5300 || chan->freq == 5320)) {
+ /*
+ * IBSS is not allowed on 5.25-5.35 GHz band
+ * due to radar detection requirements.
+ */
+ chan->flag &= ~IEEE80211_CHAN_W_IBSS;
+ }
+
+ break;
+ }
+ }
+}
+
+
+void ieee80211_set_default_regdomain(struct ieee80211_hw_mode *mode)
+{
+ int c;
+ for (c = 0; c < mode->num_channels; c++)
+ ieee80211_unmask_channel(mode->mode, &mode->channels[c]);
+}
+
+
+void ieee80211_regdomain_init(void)
+{
+ if (ieee80211_regdom == 0x40)
+ channel_range = ieee80211_mkk_channels;
+}
+
projects / openwrt / staging / blogic.git / commitdiff