ieee80211_hw_set(ar->hw, WANT_MONITOR_VIF);
ieee80211_hw_set(ar->hw, CHANCTX_STA_CSA);
ieee80211_hw_set(ar->hw, QUEUE_CONTROL);
+ ieee80211_hw_set(ar->hw, SUPPORTS_TX_FRAG);
if (!test_bit(ATH10K_FLAG_RAW_MODE, &ar->dev_flags))
ieee80211_hw_set(ar->hw, SW_CRYPTO_CONTROL);
ieee80211_hw_set(wl->hw, SUPPORTS_DYNAMIC_PS);
ieee80211_hw_set(wl->hw, SIGNAL_DBM);
ieee80211_hw_set(wl->hw, SUPPORTS_PS);
+ ieee80211_hw_set(wl->hw, SUPPORTS_TX_FRAG);
wl->hw->wiphy->cipher_suites = cipher_suites;
wl->hw->wiphy->n_cipher_suites = ARRAY_SIZE(cipher_suites);
* drivers, mac80211 packet loss mechanism will not be triggered and driver
* is completely depending on firmware event for station kickout.
*
+ * @IEEE80211_HW_SUPPORTS_TX_FRAG: Hardware does fragmentation by itself.
+ * The stack will not do fragmentation.
+ * The callback for @set_frag_threshold should be set as well.
+ *
* @NUM_IEEE80211_HW_FLAGS: number of hardware flags, used for sizing arrays
*/
enum ieee80211_hw_flags {
IEEE80211_HW_TX_AMSDU,
IEEE80211_HW_TX_FRAG_LIST,
IEEE80211_HW_REPORTS_LOW_ACK,
+ IEEE80211_HW_SUPPORTS_TX_FRAG,
/* keep last, obviously */
NUM_IEEE80211_HW_FLAGS
* The callback must be atomic.
*
* @set_frag_threshold: Configuration of fragmentation threshold. Assign this
- * if the device does fragmentation by itself; if this callback is
- * implemented then the stack will not do fragmentation.
+ * if the device does fragmentation by itself. Note that to prevent the
+ * stack from doing fragmentation IEEE80211_HW_SUPPORTS_TX_FRAG
+ * should be set as well.
* The callback can sleep.
*
* @set_rts_threshold: Configuration of RTS threshold (if device needs it)
FLAG(TX_AMSDU),
FLAG(TX_FRAG_LIST),
FLAG(REPORTS_LOW_ACK),
+ FLAG(SUPPORTS_TX_FRAG),
#undef FLAG
};
!local->ops->tdls_recv_channel_switch))
return -EOPNOTSUPP;
+ if (WARN_ON(ieee80211_hw_check(hw, SUPPORTS_TX_FRAG) &&
+ !local->ops->set_frag_threshold))
+ return -EINVAL;
+
if (WARN_ON(local->hw.wiphy->interface_modes &
BIT(NL80211_IFTYPE_NAN) &&
(!local->ops->start_nan || !local->ops->stop_nan)))
if (info->flags & IEEE80211_TX_CTL_DONTFRAG)
return TX_CONTINUE;
- if (tx->local->ops->set_frag_threshold)
+ if (ieee80211_hw_check(&tx->local->hw, SUPPORTS_TX_FRAG))
return TX_CONTINUE;
/*
/* fast-xmit doesn't handle fragmentation at all */
if (local->hw.wiphy->frag_threshold != (u32)-1 &&
- !local->ops->set_frag_threshold)
+ !ieee80211_hw_check(&local->hw, SUPPORTS_TX_FRAG))
goto out;
rcu_read_lock();
if (info->control.hw_key &&
(info->flags & IEEE80211_TX_CTL_DONTFRAG ||
- tx->local->ops->set_frag_threshold) &&
+ ieee80211_hw_check(&tx->local->hw, SUPPORTS_TX_FRAG)) &&
!(tx->key->conf.flags & IEEE80211_KEY_FLAG_GENERATE_MMIC)) {
/* hwaccel - with no need for SW-generated MMIC */
return TX_CONTINUE;