case ATH79_SOC_AR7241:
case ATH79_SOC_AR9330:
case ATH79_SOC_AR9331:
- case ATH79_SOC_QCA956X:
case ATH79_SOC_TP9343:
pdata->phy_if_mode = PHY_INTERFACE_MODE_GMII;
break;
case ATH79_SOC_AR9342:
case ATH79_SOC_AR9344:
case ATH79_SOC_QCA9533:
+ case ATH79_SOC_QCA956X:
switch (pdata->phy_if_mode) {
case PHY_INTERFACE_MODE_MII:
case PHY_INTERFACE_MODE_GMII:
iounmap(base);
}
+void __init ath79_setup_qca956x_eth_cfg(u32 mask)
+{
+ void __iomem *base;
+ u32 t;
+
+ base = ioremap(QCA956X_GMAC_BASE, QCA956X_GMAC_SIZE);
+
+ t = __raw_readl(base + QCA956X_GMAC_REG_ETH_CFG);
+
+ t &= ~(QCA956X_ETH_CFG_SW_ONLY_MODE |
+ QCA956X_ETH_CFG_SW_PHY_SWAP);
+
+ t |= mask;
+
+ __raw_writel(t, base + QCA956X_GMAC_REG_ETH_CFG);
+ /* flush write */
+ __raw_readl(base + QCA956X_GMAC_REG_ETH_CFG);
+
+ iounmap(base);
+}
+
static int ath79_eth_instance __initdata;
void __init ath79_register_eth(unsigned int id)
{
void ath79_setup_ar934x_eth_cfg(u32 mask);
void ath79_setup_ar934x_eth_rx_delay(unsigned int rxd, unsigned int rxdv);
void ath79_setup_qca955x_eth_cfg(u32 mask);
+void ath79_setup_qca956x_eth_cfg(u32 mask);
#endif /* _ATH79_DEV_ETH_H */
u8 is_ar724x:1;
u8 has_ar8216:1;
u8 use_flow_control:1;
+ u8 is_qca956x:1;
struct ag71xx_switch_platform_data *switch_data;
void (*ddr_flush)(void);
void (*set_speed)(int speed);
+ void (*update_pll)(u32 pll_10, u32 pll_100, u32 pll_1000);
u32 fifo_cfg1;
u32 fifo_cfg2;
--- /dev/null
+--- a/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
++++ b/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
+@@ -157,6 +157,10 @@
+ #define QCA956X_EHCI0_BASE 0x1b000000
+ #define QCA956X_EHCI1_BASE 0x1b400000
+ #define QCA956X_EHCI_SIZE 0x200
++#define QCA956X_GMAC_SGMII_BASE (AR71XX_APB_BASE + 0x00070000)
++#define QCA956X_GMAC_SGMII_SIZE 0x64
++#define QCA956X_PLL_BASE (AR71XX_APB_BASE + 0x00050000)
++#define QCA956X_PLL_SIZE 0x50
+ #define QCA956X_GMAC_BASE (AR71XX_APB_BASE + 0x00070000)
+ #define QCA956X_GMAC_SIZE 0x64
+
+@@ -404,6 +408,7 @@
+ #define QCA956X_PLL_DDR_CONFIG_REG 0x08
+ #define QCA956X_PLL_DDR_CONFIG1_REG 0x0c
+ #define QCA956X_PLL_CLK_CTRL_REG 0x10
++#define QCA956X_PLL_ETH_XMII_CONTROL_REG 0x30
+
+ #define QCA956X_PLL_CPU_CONFIG_REFDIV_SHIFT 12
+ #define QCA956X_PLL_CPU_CONFIG_REFDIV_MASK 0x1f
+@@ -1186,4 +1191,16 @@
+ #define QCA955X_ETH_CFG_TXE_DELAY_MASK 0x3
+ #define QCA955X_ETH_CFG_TXE_DELAY_SHIFT 20
+
++/*
++ * QCA956X GMAC Interface
++ */
++
++#define QCA956X_GMAC_REG_ETH_CFG 0x00
++
++#define QCA956X_ETH_CFG_SW_ONLY_MODE BIT(7)
++#define QCA956X_ETH_CFG_SW_PHY_SWAP BIT(8)
++#define QCA956X_ETH_CFG_SW_PHY_ADDR_SWAP BIT(9)
++#define QCA956X_ETH_CFG_SW_APB_ACCESS BIT(10)
++#define QCA956X_ETH_CFG_SW_ACC_MSB_FIRST BIT(13)
++
+ #endif /* __ASM_MACH_AR71XX_REGS_H */
#define AR71XX_UART_BASE (AR71XX_APB_BASE + 0x00020000)
#define AR71XX_UART_SIZE 0x100
#define AR71XX_USB_CTRL_BASE (AR71XX_APB_BASE + 0x00030000)
-@@ -218,6 +218,9 @@
+@@ -222,6 +222,9 @@
#define QCA953X_DDR_REG_FLUSH_PCIE 0xa8
#define QCA953X_DDR_REG_FLUSH_WMAC 0xac
void __iomem *reg = ath79_gpio_get_function_reg();
--- a/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
+++ b/arch/mips/include/asm/mach-ath79/ar71xx_regs.h
-@@ -850,6 +850,7 @@
+@@ -855,6 +855,7 @@
#define AR71XX_GPIO_REG_INT_PENDING 0x20
#define AR71XX_GPIO_REG_INT_ENABLE 0x24
#define AR71XX_GPIO_REG_FUNC 0x28
#define AR934X_GPIO_REG_OUT_FUNC0 0x2c
#define AR934X_GPIO_REG_OUT_FUNC1 0x30
-@@ -974,6 +975,8 @@
+@@ -979,6 +980,8 @@
#define AR724X_GPIO_FUNC_UART_EN BIT(1)
#define AR724X_GPIO_FUNC_JTAG_DISABLE BIT(0)