Manuel Lauss <manuel.lauss@gmail.com> writes:
I introduced it as a fallback because early revisions of Alchemy hardware
we shipped had a non-functional 32kHz timer and had to rely on the r4k
timer instead. Previously the r4k timer was initialized regardless, but
it's useless with the "wait" instruction.
So long story short: I need either the on-chip 32kHz timer OR the r4k
timer if the 32kHz one is unusable, but not both, and r4k timer is useless
when au1k_idle is in use.
The current in-kernel Alchemy boards all work with the 32kHz timer, so I'm
not against removing R4K_LIB symbols.
Signed-off-by: Steven J. Hill <sjhill@mips.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
bool "Alchemy processor based machines"
select 64BIT_PHYS_ADDR
select CEVT_R4K_LIB
- select CSRC_R4K_LIB
+ select CSRC_R4K
select IRQ_CPU
select SYS_HAS_CPU_MIPS32_R1
select SYS_SUPPORTS_32BIT_KERNEL
config CSRC_POWERTV
bool
-config CSRC_R4K_LIB
- bool
-
config CSRC_R4K
- select CSRC_R4K_LIB
bool
config CSRC_SB1250
/*
* Initialize the count register as a clocksource
*/
-#ifdef CONFIG_CSRC_R4K_LIB
+#ifdef CONFIG_CSRC_R4K
extern int init_r4k_clocksource(void);
#endif
obj-$(CONFIG_CSRC_BCM1480) += csrc-bcm1480.o
obj-$(CONFIG_CSRC_IOASIC) += csrc-ioasic.o
obj-$(CONFIG_CSRC_POWERTV) += csrc-powertv.o
-obj-$(CONFIG_CSRC_R4K_LIB) += csrc-r4k.o
+obj-$(CONFIG_CSRC_R4K) += csrc-r4k.o
obj-$(CONFIG_CSRC_SB1250) += csrc-sb1250.o
obj-$(CONFIG_SYNC_R4K) += sync-r4k.o