[MIPS] EMMA2RH: remove dead KGDB code

Get rid of the cross-arch KGDB specific code which shouldn't have been
there in the first place...

Signed-off-by: Sergey Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

diff --git a/arch/mips/emma2rh/markeins/setup.c b/arch/mips/emma2rh/markeins/setup.c
index b29a447392306056bdbe2ca877d171c39e876f94..2f060e1ed36c674c0e9da4e0d11f281edc8d07a0 100644 (file)
--- a/arch/mips/emma2rh/markeins/setup.c
+++ b/arch/mips/emma2rh/markeins/setup.c
@@ -115,30 +115,6 @@ extern void markeins_irq_setup(void);
 
 static void inline __init markeins_sio_setup(void)
 {
-#ifdef CONFIG_KGDB_8250
-       struct uart_port emma_port;
-
-       memset(&emma_port, 0, sizeof(emma_port));
-
-       emma_port.flags =
-           UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
-       emma_port.iotype = UPIO_MEM;
-       emma_port.regshift = 4; /* I/O addresses are every 8 bytes */
-       emma_port.uartclk = 18544000;   /* Clock rate of the chip */
-
-       emma_port.line = 0;
-       emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR0_BASE + 3);
-       emma_port.membase = (u8*)emma_port.mapbase;
-       early_serial_setup(&emma_port);
-
-       emma_port.line = 1;
-       emma_port.mapbase = KSEG1ADDR(EMMA2RH_PFUR1_BASE + 3);
-       emma_port.membase = (u8*)emma_port.mapbase;
-       early_serial_setup(&emma_port);
-
-       emma_port.irq = EMMA2RH_IRQ_PFUR1;
-       kgdb8250_add_port(1, &emma_port);
-#endif
 }
 
 void __init plat_mem_setup(void)