Pull networking fixes from David Miller:
1) Fix rtlwifi crash, from Larry Finger.
2) Memory disclosure in appletalk ipddp routing code, from Vlad
Tsyrklevich.
3) r8152 can erroneously split an RX packet into multiple URBs if the
Rx FIFO is not empty when we suspend. Fix this by waiting for the
FIFO to empty before suspending. From Hayes Wang.
4) Two GRO fixes (enter slow path when not enough SKB tail room exists,
disable frag0 optimizations when there are IPV6 extension headers)
from Eric Dumazet and Herbert Xu.
5) A series of mlx5e bug fixes (do source udp port offloading for
tunnels properly, Ip fragment matching fixes, handling firmware
errors properly when installing TC rules, etc.) from Saeed Mahameed,
Or Gerlitz, Roi Dayan, Hadar Hen Zion, Gil Rockah, and Daniel
Jurgens.
6) Two VRF fixes from David Ahern (don't skip multipath selection for
VRF paths, disallow VRF to be configured with table ID 0).
* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net: (35 commits)
net: vrf: do not allow table id 0
net: phy: marvell: fix Marvell
88E1512 used in SGMII mode
sctp: Fix spelling mistake: "Atempt" -> "Attempt"
net: ipv4: Fix multipath selection with vrf
cgroup: move CONFIG_SOCK_CGROUP_DATA to init/Kconfig
gro: use min_t() in skb_gro_reset_offset()
net/mlx5: Only cancel recovery work when cleaning up device
net/mlx5e: Remove WARN_ONCE from adaptive moderation code
net/mlx5e: Un-register uplink representor on nic_disable
net/mlx5e: Properly handle FW errors while adding TC rules
net/mlx5e: Fix kbuild warnings for uninitialized parameters
net/mlx5e: Set inline mode requirements for matching on IP fragments
net/mlx5e: Properly get address type of encapsulation IP headers
net/mlx5e: TC ipv4 tunnel encap offload error flow fixes
net/mlx5e: Warn when rejecting offload attempts of IP tunnels
net/mlx5e: Properly handle offloading of source udp port for IP tunnels
gro: Disable frag0 optimization on IPv6 ext headers
gro: Enter slow-path if there is no tailroom
mlx4: Return EOPNOTSUPP instead of ENOTSUPP
net/af_iucv: don't use paged skbs for TX on HiperSockets
...