* to be saved again on kernel mode stack, as part of pt_regs.
*-------------------------------------------------------------*/
.macro PROLOG_FREEUP_REG reg, mem
-#ifdef CONFIG_SMP
+#ifndef ARC_USE_SCRATCH_REG
sr \reg, [ARC_REG_SCRATCH_DATA0]
#else
st \reg, [\mem]
.endm
.macro PROLOG_RESTORE_REG reg, mem
-#ifdef CONFIG_SMP
+#ifndef ARC_USE_SCRATCH_REG
lr \reg, [ARC_REG_SCRATCH_DATA0]
#else
ld \reg, [\mem]
#define ARC_REG_SCRATCH_DATA0 0x46c
#endif
+#if defined(CONFIG_ISA_ARCV2) || !defined(CONFIG_SMP)
+#define ARC_USE_SCRATCH_REG
+#endif
+
/* Bits in MMU PID register */
#define __TLB_ENABLE (1 << 31)
#define __PROG_ENABLE (1 << 30)
*/
cpumask_set_cpu(cpu, mm_cpumask(next));
-#ifndef CONFIG_SMP
+#ifdef ARC_USE_SCRATCH_REG
/* PGD cached in MMU reg to avoid 3 mem lookups: task->mm->pgd */
write_aux_reg(ARC_REG_SCRATCH_DATA0, next->pgd);
#endif
* Thus use this macro only when you are certain that "current" is current
* e.g. when dealing with signal frame setup code etc
*/
-#ifndef CONFIG_SMP
+#ifdef ARC_USE_SCRATCH_REG
#define pgd_offset_fast(mm, addr) \
({ \
pgd_t *pgd_base = (pgd_t *) read_aux_reg(ARC_REG_SCRATCH_DATA0); \
write_aux_reg(ARC_REG_PID, MMU_ENABLE);
/* In smp we use this reg for interrupt 1 scratch */
-#ifndef CONFIG_SMP
+#ifdef ARC_USE_SCRATCH_REG
/* swapper_pg_dir is the pgd for the kernel, used by vmalloc */
write_aux_reg(ARC_REG_SCRATCH_DATA0, swapper_pg_dir);
#endif
lr r2, [efa]
-#ifndef CONFIG_SMP
+#ifdef ARC_USE_SCRATCH_REG
lr r1, [ARC_REG_SCRATCH_DATA0] ; current pgd
#else
GET_CURR_TASK_ON_CPU r1