e1000e: Clear ULP configuration register on ULP exit

There have been bugs caused by HW ULP configuration settings not being
properly cleared after cable connect in V-Pro capable systems.
This caused HW to get out of sync occasionally.
The fix ensures that ULP settings are cleared in HW after
LAN cable re-connect.

Signed-off-by: Raanan Avargil <raanan.avargil@intel.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.c b/drivers/net/ethernet/intel/e1000e/ich8lan.c
index e7ccf5ffa835bc98f9c79c6fa583087ba52d361b..c0f4887ea44d8c2f157cb9c63555acb5217ff1c9 100644 (file)
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.c
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.c
@@ -1328,6 +1328,8 @@ static s32 e1000_disable_ulp_lpt_lp(struct e1000_hw *hw, bool force)
                     I218_ULP_CONFIG1_RESET_TO_SMBUS |
                     I218_ULP_CONFIG1_WOL_HOST |
                     I218_ULP_CONFIG1_INBAND_EXIT |
+                    I218_ULP_CONFIG1_EN_ULP_LANPHYPC |
+                    I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST |
                     I218_ULP_CONFIG1_DISABLE_SMB_PERST);
        e1000_write_phy_reg_hv_locked(hw, I218_ULP_CONFIG1, phy_reg);
 

diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.h b/drivers/net/ethernet/intel/e1000e/ich8lan.h
index 7d85f002c3d216d5c6036316119679c17b5ca340..2311f6003f58cedcc0d726a31c05b69d0b8b7bcd 100644 (file)
--- a/drivers/net/ethernet/intel/e1000e/ich8lan.h
+++ b/drivers/net/ethernet/intel/e1000e/ich8lan.h
@@ -188,6 +188,10 @@
 #define I218_ULP_CONFIG1_INBAND_EXIT   0x0020  /* Inband on ULP exit */
 #define I218_ULP_CONFIG1_WOL_HOST      0x0040  /* WoL Host on ULP exit */
 #define I218_ULP_CONFIG1_RESET_TO_SMBUS        0x0100  /* Reset to SMBus mode */
+/* enable ULP even if when phy powered down via lanphypc */
+#define I218_ULP_CONFIG1_EN_ULP_LANPHYPC       0x0400
+/* disable clear of sticky ULP on PERST */
+#define I218_ULP_CONFIG1_DIS_CLR_STICKY_ON_PERST       0x0800
 #define I218_ULP_CONFIG1_DISABLE_SMB_PERST     0x1000  /* Disable on PERST# */
 
 /* SMBus Address Phy Register */