Alex reported the following:
"
I'm doing some MDIO work on a freescale/NXP platform and I bumped into
errors with this command:
=> mdio r emdio#3 5 3
Reading from bus emdio#3
"Synchronous Abort" handler, esr 0x8600000e
elr:
ffffffff862b8000 lr :
000000008200cce4 (reloc)
...
mdio list does not list any PHYs currently because ethernet is using DM
and the interfaces are not probed at this time. The PHY does exist
on the bus though.
The above scenario works with this commit reverted:
e55047ec51a662c12ed53ff543ec7cdf158b2137 cmd: mdio: Switch to generic
helpers when accessing the registers
The current code using generic helpers only works for PHYs that have
been registered and show up in bus->phymap and crashes for arbitrary
IDs. I find it useful to allow reading from other addresses over MDIO
too, certainly helpful for people debugging MDIO on various boards.
"
Fix this by reverting to use the raw MDIO bus operations in case there
is no PHY probed based on DT at the specified address.
This restores the old behavior for these PHYs, which means that the
newly introduced MMD-over-C22 helpers won't be available for them, but
at least they will be accessible again without crashing the system.
Fixes: commit e55047ec51a6 ("cmd: mdio: Switch to generic helpers when accessing the registers")
Reported-by: Alex Marginean <alexm.osslist@gmail.com>
Signed-off-by: Vladimir Oltean <olteanv@gmail.com>
Reviewed-by: Alex Marginean <alexm.osslist@gmail.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
for (devad = devadlo; devad <= devadhi; devad++) {
for (reg = reglo; reg <= reghi; reg++) {
- if (!extended)
+ if (!phydev)
+ err = bus->write(bus, addr, devad,
+ reg, data);
+ else if (!extended)
err = phy_write_mmd(phydev, devad,
reg, data);
else
for (reg = reglo; reg <= reghi; reg++) {
int val;
- if (!extended)
+ if (!phydev)
+ val = bus->read(bus, addr, devad, reg);
+ else if (!extended)
val = phy_read_mmd(phydev, devad, reg);
else
val = phydev->drv->readext(phydev, addr,